Jess-- / Chinese-Heater-Temperature-AddonLinks
Addon for chinese diesel heaters to enable better (or different) temperature control
☆19Updated 6 years ago
Alternatives and similar repositories for Chinese-Heater-Temperature-Addon
Users that are interested in Chinese-Heater-Temperature-Addon are comparing it to the libraries listed below
Sorting:
- Library for working with JBD BMS☆75Updated last year
- Arduino project to control webasto heater via W-bus☆48Updated 7 years ago
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆57Updated 9 months ago
- ESP32 based CAN development board☆178Updated 3 years ago
- Emulación del protocolo CANBUS de Pylontech, para comunicación con inversores fotovoltaicos, usando un ESP32☆13Updated last month
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆115Updated last year
- An opensource solution for connecting OBD2 straight to the Nissan Leaf battery☆63Updated last year
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆75Updated last year
- Arduino library for communicating with Daly BMSs over UART☆112Updated last year
- diy BMS version 4 for Nissan Leaf cells☆20Updated 4 years ago
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆327Updated 9 months ago
- CutbyCaschy Ctrl for diesel heater. Piggy-back interface to 4button RF remote☆18Updated last year
- Arduino Interface for cheap 2.4ghz RF enabled Solar Micro Inverters☆66Updated 2 years ago
- Hardware circuit diagram for interfacing to the Webasto WBUS interface from a PC/Arduino☆24Updated 5 years ago
- ESP32 BLE Tire Pressure Management System☆111Updated 5 years ago
- ☆62Updated 6 years ago
- ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).☆33Updated last year
- ☆42Updated 5 years ago
- A very flexible ESP32 power meter / energy meter with SCT-013-0x0, ZMPT101B, ACS712 sensors☆44Updated last year
- ☆30Updated 3 years ago
- An Arduino based LINBUS stack and signal interceptor/injector.☆195Updated 6 years ago
- How to connect to a Sofar HYD3600 Inveter and 2 Pylontech US3000 batteries☆20Updated 4 years ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆99Updated 5 years ago
- ☆20Updated 7 months ago
- Arduino LIN Interface☆30Updated 8 years ago
- Arduino ESP32 library supporting the on-chip CAN module☆351Updated 7 months ago
- Converts the JK-BMS RS485 data to Pylontech CAN data☆91Updated 6 months ago
- An ESP32 based BMS master for CAN based remote boards. Makes use of SimpBMS code for decoding the module data messages.☆16Updated 2 years ago
- The Valden Heat Pump controller is a platform to precisely control heat pumps☆145Updated 4 years ago
- Lightweight arduino library to read basic data using the VE.Direct protocol from Victron Energy☆95Updated 2 years ago