Hoektronics / ShukongjiLinks
Experimental Open Hardware CNC system.
☆21Updated 11 years ago
Alternatives and similar repositories for Shukongji
Users that are interested in Shukongji are comparing it to the libraries listed below
Sorting:
- LinuxCNC to fpga-over-spi driver☆25Updated 8 years ago
- Machinekit Featured Application for Enhanced Motion Controller from LinuxCNC☆15Updated 3 years ago
- Controller board for wheeled robots, based on the ESP8266 with three DC motors drivers, one-cell LiPo battery charger and Wifi connectivi…☆15Updated 9 years ago
- Open-BLDC brushless motor QT simulator GUI☆15Updated 12 years ago
- CNC laser cutter controller, compatible with LaserSaur but better.☆20Updated 12 years ago
- XDisplace are a complete solution to mill, dispense solder paste and pixk and place components to a pcb in one process!☆12Updated 8 years ago
- My LinuxCNC / EtherCAT notes☆59Updated last week
- The I/O side ARM MCU firmware for Granite Devices ARGON servo motor drive.☆18Updated 4 years ago
- An application to send G-Codes and control my milling machine.☆21Updated 2 years ago
- CNC and design files for DIY pick and place machines, auto and manual versions☆57Updated 10 years ago
- Affordable and precise XY and Z movement platform for scientific experimentation☆11Updated 8 years ago
- Embedded software (firmware) for the laser system and components, including configuration files☆27Updated last year
- Hostmot2 FPGA code for SoC/FPGA platforms from Altera and Xilinx☆31Updated last year
- CRAMPS - A Cape version of the RAMPS-FD design for 3D printing☆45Updated 6 years ago
- Configuration and diagnostic tool for Mesa Electronics PCI(E)/ETH/EPP/USB/SPI boards☆36Updated 2 months ago
- HostMot2 FPGA firmware☆20Updated 4 years ago
- grbl for stm32 with nucleo stepper drivers☆33Updated 4 years ago
- Advanced QT app for openPOWERLINK v2.x☆9Updated 10 years ago
- (Deprecated attempt at) A Smoothie firmware port to the Smoothieboard v2 boards.☆34Updated 7 years ago
- Touchscreen UI for LinuxCNC☆33Updated 5 years ago
- Code and configurations to use LinuxCNC to control a RepRap 3D printer☆20Updated 12 years ago
- MDX LabPanel - A Scilab-Programmed GUI Control Panel for Roland MODELA MDX-15/20 CNC Machine☆13Updated 3 years ago
- Analog speed control of Brushed DC Motor☆25Updated last year
- STL to G-code for CNC milling☆47Updated 2 weeks ago
- Full-featured user interface for Machinekit☆35Updated 5 years ago
- Firmware for the DIY Desktop CNC mill project CNC UNO☆17Updated 6 years ago
- GUI for grbl.☆51Updated 7 years ago
- QT Marlin setting configuration tool☆77Updated 8 years ago
- STM32-based servo/CNC/3D-printer controller☆43Updated 12 years ago
- Script to generate Hypocycloid Gears Sketch☆25Updated 10 years ago