F0rged / LittleWheelsESC
An open source arduino based ESC project for 12v to 24v kids ride-on toys
☆10Updated 5 years ago
Alternatives and similar repositories for LittleWheelsESC
Users that are interested in LittleWheelsESC are comparing it to the libraries listed below
Sorting:
- Android control application for ESP32 add-on module of TSDZ2 eBike motor☆10Updated last year
- Arduino Library for CAN Bed☆26Updated 4 years ago
- Vesc UART <-> Esp32 Wifi bridge☆15Updated 4 years ago
- S06S 250W Torque Simulation Sine Wave Controller☆14Updated 7 years ago
- CANbus shift light, works with Neopixels and MCP2515 to make a shiftlight that works over CAN.☆17Updated 3 months ago
- Optimized OpenSource firmware for TongSheng TSDZ2 mid drive ebike motor☆11Updated last year
- An open source engine management☆27Updated 3 months ago
- F405 Pill for running VESC based motor control from a Black/Blue Pill footprint☆10Updated last year
- A minimal raspberry pi 3 or 4 image that runs VESC Tool☆29Updated 3 years ago
- ☆41Updated 5 years ago
- Arduino Pedal Assist Sensor to Throttle (voltage control).☆10Updated 3 years ago
- ☆30Updated 6 months ago
- Hardware designs for the Macchina A0☆16Updated 3 years ago
- Firmware for the ESP32 add on Board☆12Updated last year
- The source code for the VESC Express☆52Updated last week
- An ESP32 based BMS master for CAN based remote boards. Makes use of SimpBMS code for decoding the module data messages.☆15Updated 2 years ago
- A simple display for a VESC based on a TTGO-Display board from LilyGo☆25Updated 2 years ago
- SWCAN add-on board for Open Vehicle Monitoring System☆30Updated 5 years ago
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆28Updated 7 months ago
- Hardware circuit diagram for interfacing to the Webasto WBUS interface from a PC/Arduino☆23Updated 5 years ago
- Automatic Transmission Controller designed by Seaside Customs Garage☆12Updated 6 years ago
- ☆23Updated 5 years ago
- CAN_Interface for ESP32 (Cannelloni Protocol)☆55Updated 4 years ago
- A simple display graphics editor, mostly useful for the VESC Wand☆11Updated 2 years ago
- A library of kicad symbols and footprints for parts used across the Speeduino boards☆16Updated 11 months ago
- Peak and hold injector driver for low-Z injectors.☆14Updated 2 years ago
- A reflow Hotplate for DIY SMD assembly☆21Updated 4 months ago
- CAN-based Formula SAE / FSAE race car dashboard with data logging☆11Updated 5 years ago
- initial☆11Updated 7 years ago
- Hellen-One Hardware Platform for rusEFI Engine Management System☆23Updated 2 weeks ago