EQMOD / REJSACAN_OBDWEBLinks
A WEB Based OBDII Dongle Platform using the REJSACAN ESP32-S3 OBDII DONGLE
☆17Updated last year
Alternatives and similar repositories for REJSACAN_OBDWEB
Users that are interested in REJSACAN_OBDWEB are comparing it to the libraries listed below
Sorting:
- CAN_Interface for ESP32 (Cannelloni Protocol)☆55Updated 4 years ago
- Experimental - OBD2 to feed custom device via bluetooth☆88Updated 10 months ago
- ☆55Updated 6 months ago
- ☆136Updated 2 years ago
- Decode tire pressure monitoring system TPMS BLE 433MHz CC1101 ESP8266 ESP32☆85Updated 2 years ago
- Bridge between Wifi and CAN. Minimal variant of the ESP32RET. Using ESP32s3☆30Updated 9 months ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆112Updated 10 months ago
- ☆41Updated 5 years ago
- ESP32 BLE Tire Pressure Management System☆102Updated 4 years ago
- This is an Arduino library providing an emulation of the CAN communication protocol of the BMS (battery management system) on a Renault T…☆85Updated 2 years ago
- ☆19Updated 2 years ago
- Monitor Canbus traffic☆128Updated last month
- ESP32 OBD-II adapter☆15Updated last year
- Car Dashboard using Arduino Leonardo, OBDII to UART adapter and Intelligent Nextion Display☆31Updated 9 months ago
- ☆41Updated 5 years ago
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆54Updated 6 months ago
- An ESP32 CAN 2.0B library☆66Updated last month
- CAN Reverse engineering tool for ESP32 based boards (specifically EVTV ESP32Due)☆293Updated 6 months ago
- ☆62Updated 6 years ago
- ☆50Updated 8 years ago
- A simple Arduino sketch that allows you to send data to Torque Pro for Android☆23Updated 3 years ago
- Custom dashboard in car that reads OBD2 via bluetooth☆23Updated 3 years ago
- ESP32 slcan compatible device☆101Updated 3 years ago
- Convert your ESP32 based development boards like Wemos, NodeMCU, Lolin etc. to CAN to Bluetooth Low Energy adapter.☆28Updated 6 years ago
- Program for reading data from a Xiaoxiang smart BMS and printing to an OLED display☆21Updated 4 years ago
- Arduino ESP32 library supporting the on-chip CAN module☆331Updated 3 months ago
- A simple EVSE (electric vehicle supply equipment or "wall charger") built using an Arduino and open source software.☆12Updated last year
- Read and Write Library for Overkill Solar BMSs☆17Updated 2 years ago
- ESP32 based CAN development board☆175Updated 3 years ago
- Custom Turbo Boost Gauge using ESP32S3 with Round Waveshare IPS Display☆113Updated 11 months ago