DragonRailway / EMD-LocomotivesLinks
☆16Updated 6 months ago
Alternatives and similar repositories for EMD-Locomotives
Users that are interested in EMD-Locomotives are comparing it to the libraries listed below
Sorting:
- CAN bus extruder, more resistant to noise,reduce a lot of wires for your 3D printer☆116Updated 2 years ago
- Dokumentation for the Hardware, Firmware, Guidelines☆36Updated 2 months ago
- A low cost stepper motor analyzer that uses wireless BLE link to display the data in real time on a Windows/Mac/Linux PC.☆55Updated 2 years ago
- A Top Feed Extruder for "Roof" Mounting loosely based on M3.1☆20Updated 5 years ago
- A Pendant for FluidNC CNC Firmware☆73Updated 4 months ago
- Independent laser motion sensor to sense filament clog or runout☆25Updated 2 years ago
- ☆38Updated 2 years ago
- DIY WiFi Filament dryer☆170Updated last year
- The Millenium Long John Toolsetter is a low cost, low profile and simple tool height setter☆30Updated 2 years ago
- Parametric tracks for your 3D printed Model Railway☆21Updated 6 months ago
- Experimental CoreXY 3D printer☆19Updated 2 years ago
- SK-Tank CoreXY 3D Printer resources☆35Updated 8 months ago
- List of controllers supported by grblHAL☆58Updated 9 months ago
- Beam by Fiberpunk - ESP32☆77Updated 2 years ago
- Blackbox is a high end CoreXY Tool Changing 3D Printer. Aiming for reasonable build volume, fast print speeds and high resolution.☆102Updated 10 months ago
- DIY Printed small PCB CNC for fast Prototyping☆53Updated 4 years ago
- MaybeCube: fully featured, rigid, high speed, affordable, coreXY linear rails 3D printer☆40Updated last year
- A set of node-red nodes to interface with the Moonraker API for Klipper☆18Updated 4 months ago
- Multi-sensor intelligent environmental Monitor☆18Updated last year
- The files needed to build MokeyLaser V1, including 3D models☆157Updated 2 years ago
- CorEssentials is an open source corexy 3D printer.☆26Updated 4 years ago
- Fiberpunk Holo from: https://github.com/peng-zhihui/HoloCubic☆119Updated 2 years ago
- In this repo you find the firmware and all informations to use an Bigtreetech SKR 1.4 Turbo board in an Anycubic I3 Mega☆18Updated 5 years ago
- RELOCATED TO KLIPPO: A Klipper module that enables a network connection with Cura.☆12Updated 3 years ago
- CroXY 3D Printer called Defiant☆34Updated 2 years ago
- Experimental grblHAL post processor with canned cycles and 4th axis support☆15Updated last year
- ESP32 DIY Digital Readout☆109Updated 6 years ago
- Alternate firmware for Orbion mouse CAD☆21Updated 6 months ago
- 3D printed RC race car with custom electronics☆90Updated 4 months ago
- Camera-based XY skew calibration for Klipper using a toolhead-mounted camera and a ChArUco board.☆66Updated 2 months ago