Chiumanfu / LMIC-node_Sensor-for-Helium-Network
An example LORA sensor operating on the Helium network. Built off the awesome LMIC-node repo.
☆19Updated 3 years ago
Alternatives and similar repositories for LMIC-node_Sensor-for-Helium-Network:
Users that are interested in LMIC-node_Sensor-for-Helium-Network are comparing it to the libraries listed below
- datasheet and Arduino demo code for LoRa Radio Node v1.0☆48Updated 6 years ago
- A Fork of the popular ESP8266 single channel gateway adapted to ESP32 on the 915Mhz band.☆74Updated 4 years ago
- ☆32Updated 3 years ago
- Version 5 of Single Channel LoRa Gateway☆61Updated 4 years ago
- ATtiny85 based LoRa atmospheric sensor board with BME280☆28Updated 6 years ago
- Lmic (LoraWAN-in-C) modified to C++☆67Updated 2 months ago
- ☆40Updated 4 years ago
- Development for LoRa☆19Updated 4 years ago
- ☆13Updated 6 years ago
- TTGO ESP32 PAXCOUNTER LoRa32 V2.1 Sketch for TTN (The Things Network) (With BME280 support)☆39Updated 5 years ago
- ESP8266 with W5500 ethernet running as a gateway for ESP-Now nodes. Node demo code included.☆69Updated 6 years ago
- Arduino C++ code to communicate with a Microchip RN2483 module☆86Updated last year
- ☆82Updated 10 months ago
- 1-channel gateway based on ESP8266 mcu☆69Updated 7 years ago
- BasicMAC LoRaWAN stack that supports (but is not limited to) Arduino☆80Updated 4 years ago
- using a polynomial to get improved battery capacity information (ESP32/8266 or UNO)☆39Updated 5 years ago
- Documents and Code for use with Heltec CubeCell LoraWAN Node Boards, Capsule, and Modules☆28Updated 5 years ago
- LoraWAN-in-C library, adapted to run under the Arduino environment☆40Updated 7 years ago
- Library for Arduino compatible with Cayenne Low Power Payload☆114Updated 5 months ago
- Battery Voltage monitor with no current drain breakout board☆70Updated 6 years ago
- ESP8266 WeMos Shield for HopeRF RFM95 RFM96 RFM98 Lora module☆234Updated 4 years ago
- ☆62Updated 7 years ago
- ☆37Updated 4 years ago
- A very basic TX and RX demo for the ESP-NOW Protocol for the ESP8266 & ESP32☆89Updated 2 years ago
- NodeMCU ESP8266 RF Gateway and Display Board☆116Updated 6 years ago
- Code to wake up ESP8266 using external interrupt and send a MQTT message and turn itself off after external signal has vanished.☆27Updated 6 years ago
- This decoder can be used for all LoRa nodes which are built based on RUI.☆27Updated 4 years ago
- ☆71Updated 7 years ago
- SImple diagnostics for ESP8266 and ESP32 devices☆35Updated 2 years ago
- A ESP32 Arduino BLE Scanner☆88Updated 2 years ago