CentyLab / AP33772S-CentyLabLinks
AP33772S USB C PD 3.1 Controller Arduino Library
☆28Updated 5 months ago
Alternatives and similar repositories for AP33772S-CentyLab
Users that are interested in AP33772S-CentyLab are comparing it to the libraries listed below
Sorting:
- 4 layer version of the Epi 32U4☆57Updated last year
- High resolution quadrature encoder using the PIO on the RP2040☆56Updated 2 months ago
- ☆18Updated last year
- Quick and dirty PIC16F72 programmer using the Raspberry Pi Pico and MicroPython☆33Updated last year
- Read and write files to flash, USB mass storage and SD cards in a unified way.☆14Updated 2 weeks ago
- ☆44Updated 3 months ago
- A fully custom DIY mechanical keyboard☆26Updated last year
- Arduino library for making seesaw peripherals using Arduino core!☆29Updated 9 months ago
- Example project for using the picowota Pico W OTA bootloader☆29Updated 2 years ago
- ☆33Updated 4 months ago
- A minimal breakout board based on the Raspberry Pi RP2040 processor.☆37Updated last year
- Custom firmware for cheap STC Based Soldering iron using PlatformIO and SDCC 8051 based☆50Updated 2 years ago
- ☆28Updated 3 months ago
- HID over I2C demonstration☆41Updated 11 months ago
- Bluetooth LE temperature controller for the 946C electronic hot plate☆111Updated last year
- Generates a 2D touchpad / trackpad XY pattern and creates a fully routed PCB out of it☆53Updated 4 months ago
- Library for Arduino and ATmega series processors to read the processor's Vcc voltage and percentage of capacity (for battery based projec…☆78Updated 5 months ago
- FM Radio with RDS☆74Updated 3 months ago
- ☆28Updated last year
- Enhancing Nice-Power Bench Power Supplies with ESP8266 Connectivity☆64Updated 6 months ago
- LittleFS Data Uploader for Arduino-Pico☆31Updated last year
- ☆76Updated 5 months ago
- This library enables you to use SPI SD cards with RP2040-based boards such as Nano_RP2040_Connect, RASPBERRY_PI_PICO using either RP2040 …☆44Updated 2 years ago
- Arduino Core for Bouffalo Labs's RISC-V BL808 SOC☆35Updated last year
- Is it magik? Or is it just a 3d printed box for holding your solder stencils with automatic lifting and vacuum hold down?☆34Updated 3 years ago
- ☆34Updated 4 years ago
- Because it should be a crime to release a product with Micro-USB in the 2020s☆132Updated 10 months ago
- Capacitive touch control surface using Raspberry Pi Pico☆38Updated 3 months ago
- GM328A / KKMOON Transitor / Component Tester Firmware☆39Updated 5 years ago
- Arduino library for fast non-linear mapping or interpolation of values☆36Updated last year