Alternatives and similar repositories for Flexar-Driver

Users that are interested in Flexar-Driver are comparing it to the libraries listed below

• CarlBugeja / PCB-Actuator-12layer
  12-layer PCB Actuator
  ☆39Updated 2 years ago
• CarlBugeja / HeatStick
  A 10x10cm Flexible PCB Heater with an adhesive back
  ☆43Updated 3 years ago
• CarlBugeja / Foldable-Rover
  Foldable Flex PCB that folds into a Tiny Rover
  ☆25Updated 2 years ago
• CarlBugeja / PCB-Hot-Plate
  Reflowing PCBs with PCBs!
  ☆88Updated 3 years ago
• CarlBugeja / Flexar-Flexible-PCB-Actuator-2layer-v1
  Flexible PCB Actuator
  ☆10Updated 3 years ago
• CarlBugeja / Solid-State-PCB-Fan
  An experimental DIY Fan made from Flexible PCBs
  ☆13Updated 3 years ago
• kingoflolz / linear-actuator-hardware
  ☆64Updated 3 years ago
• rallekralle11 / Epi_4L
  4 layer version of the Epi 32U4
  ☆58Updated last year
• jbtronics / PCBruler
  A PCB Ruler created in KiCAD
  ☆73Updated 6 years ago
• EmanuelBender / HEX_POD
  Multi-sensor intelligent environmental Monitor
  ☆17Updated last year
• jrsikken / AEMLIC
  Solar harvesting into Lithium Ion Capacitor
  ☆17Updated last year
• ccadic / ESP32-S2-DevBoardTFT
  Esp32-S2 dev board with 240x240 IPS display
  ☆79Updated 3 years ago
• dbuezas / arduino-web-oscilloscope
  ☆140Updated 2 years ago
• CarlBugeja / Ping-Pong-LED-Ball
  A ball with 242 RGB Addressable LEDs - the size of a ping pong ball
  ☆20Updated 3 years ago
• atomic14 / kicad-coil-plugins
  Some simple plugins for generating stator coils in kicad
  ☆105Updated last year
• solderparty / flexypin_adapters_hw
  ☆46Updated 5 months ago
• luni64 / MicroMod_3.2
  NXP MK20DX256 board for the Sparkfun MicroMod system. Should be able to run Teensy 3.2 firmware
  ☆16Updated 4 years ago
• SyedTahmidMahbub / q-dpico_picprog72
  Quick and dirty PIC16F72 programmer using the Raspberry Pi Pico and MicroPython
  ☆32Updated last year
• idlehandsdev-backup / samd_hcc_mod
  A SAMD21G18 based easy to solder module.
  ☆73Updated 6 years ago
• rocketscream / TinyReflowController
  An all-in-one Arduino compatible reflow controller powered by ATtiny1634R
  ☆126Updated 3 years ago
• wattnotions / PrettySmallRobot
  ☆23Updated 2 years ago
• SeryDesigns / Battery-Charger
  Li-Ion battery charger, based on BQ24060 IC
  ☆44Updated 2 years ago
• wagiminator / ATtiny814-Power-Analyzer
  Power Supply Analyzer with USB Interface
  ☆53Updated 2 years ago
• akshaybaweja / component-tester-oled
  Component Tester in a Keychain
  ☆75Updated 3 years ago
• aeonSolutions / AeonLabs-Solder-Reflow-Plate-PCB
  Solder Reflow Plate PCB
  ☆32Updated last year
• beast-devices / ant2-usb-c-lipo-charger
  Tiniest USB-C LiPo charger
  ☆35Updated 2 years ago
• mike-rankin / ESP32_Burninator
  An ESP32 project using two linear stepper motors and a burning laser diode
  ☆60Updated 3 years ago
• ploopyco / pnp-feeder
  An automated feeder for pick and place machines.
  ☆158Updated 5 years ago
• coreWeaver / LC-Meter
  Open Source LC-Meter. All documentation included.
  ☆84Updated 3 years ago
• ripred / CPUVolt
  Library for Arduino and ATmega series processors to read the processor's Vcc voltage and percentage of capacity (for battery based projec…
  ☆80Updated 7 months ago