BEEMB / Battery-Health-MonitorLinks
Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses the BQ27441 fuel gauge IC and BQ24075 charger IC, along with an ATmega328P microcontroller, to provide real-time battery data and display it through LED bars.
☆30Updated 6 months ago
Alternatives and similar repositories for Battery-Health-Monitor
Users that are interested in Battery-Health-Monitor are comparing it to the libraries listed below
Sorting:
- ☆34Updated 2 years ago
- Multi Channel Configurable PID regulator on M5Stack Core☆48Updated last year
- A simple cost-effective demo, test, training, board for an oscilloscope made from a Raspberry Pi Pico☆59Updated 9 months ago
- ☆107Updated 2 years ago
- Multi-sensor intelligent environmental Monitor☆16Updated last year
- Ultimate Continuity tester☆30Updated 5 years ago
- A DIY, USB PD powered, pocket sized adjustable DC / lab bench power supply for electronic makers☆81Updated 4 months ago
- Raspberry Pi Pico based grblHAL Controller☆154Updated last year
- A variant of the MP2 electronic speed control with DFNW MOSFETs☆23Updated last year
- LinuxCNC configuration with EtherCAT Servo Drives Leadshine EL8 and some Beckhoff IO Modules☆37Updated last year
- ☆46Updated 10 months ago
- Open source multimeter☆141Updated 9 months ago
- A palm sized MCH (Metal Ceramic Heater) based reflow hotplate powered by USB-PD☆73Updated last year
- Adapter PCB and Kicad Library to make adding component-less program and debug footprints to your PCBs as easy as possible☆47Updated 2 months ago
- DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.☆38Updated 3 years ago
- 4 layer version of the Epi 32U4☆58Updated last year
- Open Source LC-Meter. All documentation included.☆84Updated 3 years ago
- Introducing OpenRad, a simple radiation monitoring solution powered by the SBM-20 GM tube and TTGO ESP32 microcontroller. this project of…☆58Updated 9 months ago
- 2.5kV USB 2.0 Isolator with 200mA Power Supply and Full Speed (12Mbps) Support☆64Updated 3 years ago
- Miniature closed-loop controller for brushless DC motors☆29Updated last year
- Solder Reflow Plate PCB☆32Updated last year
- Repo for PicoPD Pro hardware/software and documentation☆25Updated 2 months ago
- Simple RPM-Meter☆57Updated 2 years ago
- WiSer: Bringing wireless convenience to serial connectivity☆53Updated last year
- A brushless motor and driver built in to a business card form-factor for learning and experimenting!☆37Updated last year
- Arduino TPMS - Tire Pressure Monitoring System☆88Updated 2 months ago
- PNPASSIST: A “SMART” BUILD PLATFORM FOR MANUAL PCB ASSEMBLY☆43Updated 3 years ago
- ☆65Updated 10 months ago
- ☆144Updated 9 months ago
- Connecting cheap digital calipers to Raspberry Pi and decode readings☆123Updated 6 months ago