willglynn / taptapLinks
An implementation of the Tigo TAP protocol
☆46Updated 3 months ago
Alternatives and similar repositories for taptap
Users that are interested in taptap are comparing it to the libraries listed below
Sorting:
- Esphome component for Deye 3 phase inverters for Home Assistant☆168Updated 5 months ago
- ESPHome component to monitor a Seplos Battery Management System (Seplos-BMS) via UART or RS485☆94Updated last week
- Home Assistant Dashboard to display Inverter information. ESPHome configuration to collect inverter sensor data via modbus☆146Updated last week
- Read your Huawei Sun 2000 inverter data from Home assistant using Modbus RTU☆51Updated 2 years ago
- An ESP32 based 8 channels motor controller (to replace Homematic IP Floor Heating Actuator)☆102Updated 2 months ago
- SmartShunt ve.direct to ESPHOME node☆71Updated last year
- ☆50Updated 2 months ago
- This integration allows to monitor Bluetooth Low Energy (BLE) battery management systems (BMS) from within Home Assistant.☆154Updated this week
- Deye Firmware for LV and HV☆44Updated this week
- Kamstrup Multical 402 for esphome☆35Updated last year
- Home Assistant BLE Integration for BLE-YC01 Pool Monitor☆38Updated last week
- Solcast Integration for Home Assistant☆260Updated last week
- Adding WiFi monitoring to US2000B , US2000C , US5000 batteries.☆23Updated this week
- A smart home interface for Sofar solar and battery inverters.☆29Updated 4 months ago
- ESPHome control and monitoring of Sofar solar inverter☆19Updated 2 years ago
- Read data From Seplos BMS and send them to the Home Assistant☆44Updated last year
- esphome firmware for esp32_8ch_motor_shield☆50Updated 5 months ago
- Firmware battery safety controller (BSC)☆124Updated this week
- ESPHome component to simulate the current clamp to control the Soyosource GTN1200 limiter☆85Updated last week
- Read out Foxess T-Series Inverter to Home Assistant by using ESPHome☆37Updated 9 months ago
- Control Fairland Heatpumps without Tuya☆26Updated last year
- ESPHome component to monitor a Jikong Battery Management System (JK-BMS) via RS485 or BLE, CAN bus Goodwe/Pylon☆187Updated 8 months ago
- Use official Victron BLE endpoint for fetching data from Victron devices via Bluetooth LE via ESPHome.☆270Updated 2 months ago
- Esphome configuration for Somfy Blind☆32Updated 4 years ago
- PCB and housing for ESPHome integration with Kamstrup Multical 403 meter☆29Updated 10 months ago
- Interact with Zehnder Comfoair with esp32☆132Updated 10 months ago
- This Venus OS driver gets the data from MQTT and displays it as grid, genset or ac load meter.☆83Updated last month
- ESPHome component to read out DLMS smart meters via M-Bus☆112Updated last year
- Controller for HmIP-VdMot actuators☆59Updated 7 months ago
- Home Assistant integration for Robonect☆41Updated this week