Alternatives and similar repositories for 10A-LinearPowerSupply:

Users that are interested in 10A-LinearPowerSupply are comparing it to the libraries listed below

• DieBieEngineering / DieBieMPPT
  This is my MPPT project I am doing for a solar boat racing application called the DieBieMPPT
  ☆14Updated 7 years ago
• matthiasbock / Altium-Libraries
  Symbols, footprints and 3d models for use with Altium Designer
  ☆48Updated last year
• Stoney49th / OSHW-Multimeter
  First steps towards a fully open source hardware multimeter
  ☆21Updated 11 years ago
• tom-biskupic / LabPSU
  Open Source Lab Power Supply
  ☆28Updated 3 years ago
• SasaKaranovic / USB-Power-supply-Active-Load-Tester
  Open Source Open Hardware USB Power Supply Active Load testing unit
  ☆11Updated 7 years ago
• MegabytePhreak / scope-footswitch
  Oscilloscope to footswitch interface for run control using USBTMC
  ☆19Updated 4 years ago
• Funkton / Library
  EAGLE Master Library Folder
  ☆27Updated 6 years ago
• andysworkshop / awreflow
  Andy's Workshop Reflow Oven Controller
  ☆33Updated 7 years ago
• herptronix / tiny-DDS
  ☆20Updated 10 years ago
• estechnical / reflowOvenController
  ESTechnical Reflow Oven Controller source code and instructions
  ☆47Updated 10 years ago
• analogdevicesinc / arduino-max326xx
  Arduino core for Maxim's MAX326xx series boards
  ☆3Updated 8 months ago
• mrkindustries / openPSU
  An open source linear power supply unit for hobbyists and professionals
  ☆33Updated 3 years ago
• technoblogy / tiny-mega-i2c
  Minimal I2C master routines for the new AVR microcontrollers.
  ☆22Updated 3 years ago
• bertrik / ElectronicLoad
  Arduino software for an electronically controlled load, based on a STM32 microcontroller
  ☆21Updated 4 years ago
• kerrydwong / AD770X
  Arduino Library for AD7705/AD7706
  ☆35Updated last year
• FPGA-Computer / UPS
  My HaD UPS + Switch Mode Power Supply repository
  ☆16Updated 6 years ago
• guanix / boards
  Various PCB designs in KiCad
  ☆68Updated 10 years ago
• stevstrong / Adafruit_TFTLCD_8bit_STM32
  Adafruit TFT library using 8 bit parallel access ported to STM32
  ☆50Updated 5 years ago
• jrsikken / ElectronicLoadR3
  Hardware of Jasper's Electronic Load R3
  ☆25Updated 6 years ago
• paltatech / half-bridge
  TO247 half bridge module for EVs
  ☆15Updated 6 years ago
• wigman27 / Arduino-Programmable-Constant-Current-Power-Resistance-Load
  This is all of the code, datasheets and design files for my instructable
  ☆37Updated 9 years ago
• gbulmer / openstm32hw
  Open Source Hardware for STM32, complementing openstm32
  ☆48Updated 11 years ago
• LonelyWolf / stm8
  Wolk STM8 stuff
  ☆33Updated 10 years ago
• osPID / osPID-Hardware
  ☆31Updated 9 years ago
• monolithicpower / MagAlpha-Arduino-Library
  Arduino library for the MPS MagAlpha magnetic angle sensor.
  ☆23Updated 4 months ago
• eez-open / CF-DIC
  Current-fed dual inductor converter with wide input and output voltage range
  ☆19Updated 6 years ago
• kaktus85 / MightyWattR3
  Resources for MightyWatt R3 electronic load
  ☆31Updated last year
• UCSolarCarTeam / AltiumLibraries
  Libraries used in development of PCBs for the University of Calgary Solar Car Team
  ☆10Updated 5 years ago
• jrsikken / ElectronicLoadR2
  Hardware of Jasper's Electronic Load R2
  ☆21Updated 6 years ago
• sparkfun / Serial_Basic_Breakout-CH340G
  USB to Serial using the CH340G. Board follows the standard FTDI/Arduino pin out.
  ☆14Updated last year