tomstorey / c2500reLinks
Documentation of an effort to reverse engineer a Cisco 2501 router, with the end goal to run my own code on it (in particular FreeRTOS)
☆30Updated last year
Alternatives and similar repositories for c2500re
Users that are interested in c2500re are comparing it to the libraries listed below
Sorting:
- ☆30Updated 4 years ago
- Programming algorithm for ATF22V10C Generic Array Logic chip.☆14Updated 7 years ago
- by NF6X. Forked from: https://gitlab.com/NF6X_Retrocomputing/8051dumper☆22Updated 3 years ago
- STM32-based ISA-over-USB-adapter☆126Updated 4 years ago
- High-speed ATAPIHat for BCM2835 Secondary Memory Interface☆13Updated 4 years ago
- Collection of KiCad symbols and Footprints for retro hardware☆14Updated 2 years ago
- Bad software emulation of the Votrax SC-01 speech synthesizer☆16Updated 7 years ago
- ☆38Updated 7 years ago
- x86 emulator on Raspberry Pi Pico☆66Updated last year
- SCSI-1 Emulator for 8-bit Acorn computers such as the BBC Master and BBC Model B☆27Updated 2 years ago
- FPGA-based ROM emulator dramatically speeds software development time on computers with ROM-based storage.☆14Updated 4 years ago
- Retro Z80 computer for the Pano Logic Thin Client☆46Updated 3 years ago
- Raspberry Pi Pico Transputer Emulator☆47Updated 2 years ago
- RTL8019-based ISA network card, NE2000-compatible☆118Updated 4 years ago
- ISA-bus implementation for Arduino Mega 2560 / AVR processors☆20Updated 5 years ago
- Boot any x86-based computer from a classic parallel port.☆32Updated 5 years ago
- Open Programming Firmware for the TL866A Programmer.☆136Updated 2 years ago
- Capture the output from a computer's parallel printer port.☆36Updated last year
- uChip Simple VGA Console☆24Updated 4 years ago
- Tutorial on the IBM Micro Channel bus architecture☆38Updated 4 years ago
- IBM-PC clone based on an Intel 80386SX processor and an Altera Cyclone IV☆65Updated 8 years ago
- Notes on using TL866II Plus with minipro software on openSUSE☆62Updated 2 years ago
- Documentation of an effort to reverse engineer a Cisco 1603R router, with the end goal to run my own code on it (in particular FreeRTOS)☆19Updated 3 years ago
- Next186 SoC PC☆16Updated 11 years ago
- The Ultimate 486 Upgrade☆27Updated last year
- usb input adapter for sun workstations☆41Updated 4 months ago
- Arabell300 is an Arduino-based 300 baud modem implementing Bell 103 and ITU V.21 standards. Features Hayes-compatible AT commands, AFSK…☆25Updated last month
- Capture traffic on parallel printer port to USB☆86Updated last year
- Repair info and schematics for mostly older MFM hard drives☆33Updated 9 months ago
- PAL brute forcing using closed loop feedback w/ open-tl866☆24Updated 3 years ago