surfdado / vesc_pkgLinks
ATR Balance/Float Packages
☆12Updated 5 months ago
Alternatives and similar repositories for vesc_pkg
Users that are interested in vesc_pkg are comparing it to the libraries listed below
Sorting:
- Experimental Balance Packages☆11Updated 3 months ago
- PCBs for anyone messing with OneWheels.☆11Updated 3 years ago
- Official VESC Packages☆11Updated last month
- VESC bldc repo with my improvements☆57Updated last month
- The source code for VESC Tool. See vesc-project.com☆900Updated 3 weeks ago
- Arduino based accessory board for the balance app in BV's BLDC firmware.☆20Updated 4 years ago
- Official VESC Packages☆47Updated 2 weeks ago
- ☆24Updated last week
- ☆124Updated 3 months ago
- ☆15Updated 2 months ago
- Low-Cost Motor Controller based on the VESC 6☆372Updated 2 years ago
- The VESC motor control firmware☆12Updated 2 months ago
- VESC Firmware Archive☆38Updated last month
- Brushless DC Motor controller from Benjamin Vedder☆1,270Updated 9 years ago
- Electric skateboard oriented battery management system.☆354Updated 7 years ago
- Axial Flux Generator Designer☆18Updated last year
- An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Ar…☆14Updated 11 years ago
- ☆11Updated 2 years ago
- The TMC2209 is an ultra-silent motor driver IC for two phase stepper motors with both UART serial and step and direction interfaces.☆290Updated 4 months ago
- ☆592Updated last year
- A minimal raspberry pi 3 or 4 image that runs VESC Tool☆30Updated 3 years ago
- grblHAL core code and master Wiki☆460Updated this week
- ☆341Updated 2 years ago
- Firmware for stm32f051 based speed controllers for use with mutirotors☆992Updated last year
- [Legacy] OSRR - Open Source Racing Remote for ESK8☆11Updated 4 years ago
- ☆740Updated this week
- A simple code using the TMCStepper and AccelStepper library to test the sensor-less homing feature of the TMC2209 stepper driver☆26Updated 5 months ago
- This is the firmware for the VESC Wand remote control☆19Updated 3 years ago
- Open Source, easy to use Ethernet connected stepper motor controller. Built in FreeCAD, KiCAD and Arduino.☆565Updated 9 months ago
- Open Source FPV Drone Frame☆582Updated 4 months ago