strigeus / sparsnas_decoderLinks
Decoder for IKEA Sparsnäs using RTL-SDR
☆65Updated 4 years ago
Alternatives and similar repositories for sparsnas_decoder
Users that are interested in sparsnas_decoder are comparing it to the libraries listed below
Sorting:
- Publish info from RTL433 receiver to MQTT broker☆98Updated 7 months ago
- Serial to WiFi bridge for the Neato Botvac to enable remote control☆57Updated 5 years ago
- A custom UI dashboard for Domoticz☆26Updated 9 years ago
- Control the Itho Daalderop Eco Fan RFT using a microcontroller and CC1101 chip. The original code is fully tested using a STK500 and ATMe…☆54Updated last year
- MQTT Support for RFLink Gateway (http://www.nemcon.nl/blog2) project☆36Updated 5 months ago
- MQTT 433.92 MHz radio-frequency device gateway☆138Updated 3 years ago
- Bridge from RFLink to an mqtt broker using ESP8266 programmed with arduino IDE☆38Updated 7 years ago
- ESP8266 / H801 RGB controller using MQTT and WiFi onboarding☆30Updated 9 months ago
- MQTT Bridge for IKEA TRÅDFRI Light Gateway☆82Updated 5 years ago
- Home Automation Room Controller☆46Updated 9 years ago
- ☆39Updated 8 years ago
- Make ESP8266 works directly with Amazone Echo by emulating a WeMo switch☆35Updated 9 years ago
- Reads light switches using an Arduino and publishes events to MQTT☆30Updated 8 years ago
- Sonoff IR remote controll extension☆59Updated 8 years ago
- Control Roomba with esp8266 webinterface and simple API☆126Updated 7 years ago
- ☆24Updated 8 years ago
- Home automation occupancy sensor using load cells☆132Updated 4 years ago
- Homebridge plugin for openHAB☆49Updated 7 years ago
- Simple Hue remote based on the Sparkfun ESP8266 created in Arduino IDE☆20Updated 9 years ago
- Itead Studio SonoffSC custom firmware with MQTT and Domoticz support☆104Updated 6 years ago
- 433Mhz <-> MQTT gateway for smart home 🏡 automation☆40Updated 8 years ago
- Python serial interface for Neato robot vacuum cleaners. Testing on XV Signature Pro, should work on others.☆64Updated last month
- An MQTT server for a raspberry pi garage door opener. Most commonly used as a HomeAssistant cover component.☆75Updated 3 years ago
- 433MHz temperature and humidity sensor receiver that integrates with home automation systems.☆195Updated 2 years ago
- MiniESP for ESP01 and modules with few pins, enables GPIO 1/3 disables Serial output.☆30Updated 9 years ago
- Plugin for a rapid development of battery-powered sensors☆135Updated 3 years ago
- UNMAINTAINED - We are looking for someone to maintain ozwcp! The OpenZWave Control Panel (ozwcp for short) is an application built on the…☆128Updated 3 years ago
- RF433Mhz decoding library☆61Updated 2 years ago
- ☆18Updated 8 years ago
- Python-based IP150 'middle-ware' that uses the IP module's software port for monitoring and control of the alarm via an MQTT Broker.☆73Updated 5 years ago