snakeye / ch340g-esp32Links
ESP32 programmer built on CH340G
☆28Updated last year
Alternatives and similar repositories for ch340g-esp32
Users that are interested in ch340g-esp32 are comparing it to the libraries listed below
Sorting:
- A minimal breakout board for the new ESP32-S2-WROOM module☆123Updated 3 years ago
- This is small and fast Arduino library for Rotary Encoder with interrupts.☆85Updated 3 months ago
- Reflow Oven Controller with EPS32 and Webapp☆41Updated 6 years ago
- OSC Calibrator and High-Voltage Fuse Resetter for 8-Pin ATtinys☆58Updated 2 years ago
- Stereo VU meter using OLED screens and AVR microcontroller☆134Updated 4 years ago
- UPDI programmer software for Arduino (targets ATtiny 417 / 814 / 816 / 817 / 1614 / 1616 / 1617 and similar MCUs)☆76Updated 3 years ago
- An avr programmer for ESP32☆77Updated 6 years ago
- An improved ATMega328P with this cheap clone Logic Green LGT8F328P☆155Updated 3 years ago
- ESP32-C3 1.54inch E-ink Project☆29Updated 2 years ago
- IR Remote Control☆82Updated 3 years ago
- ESP32 How to correct the ADC☆57Updated 4 years ago
- Fast ILI9341 Arduino library optimized for AVR☆46Updated 3 years ago
- Arduino I2C scanner that scans all addresses at multiple speeds.☆25Updated 6 months ago
- OSI Layer 2 (ESB) Radio Driver for NRF52x☆40Updated 3 months ago
- Electronic Dummy Load☆50Updated 2 years ago
- IR Remote Receiver and Decoder☆49Updated 2 years ago
- ☆91Updated last year
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 3 months ago
- Load the calibration data and provide a calibrated analog read☆44Updated last year
- Simple RPM-Meter☆57Updated 2 years ago
- Single-Cell Li-Ion Battery Charger with Monitoring☆65Updated 2 years ago
- ESP32-S3 with 4.3' TFT 480x270 driver NV3041A and capacitive touch☆32Updated 11 months ago
- I2Cwrapper is a firmware framework which helps you implement Arduino based I2C target (slave) devices for control of non-I2C hardware. Su…☆32Updated 2 years ago
- This is a fork from arduino/ArduinoCore-samd on GitHub. This will be used to maintain Arduino support for SAM D|L|C (M0+ and M4F) boards …☆108Updated last year
- Library for I2C EEPROM - 24LC512, 24LC256, 24LC64/32/16/08/04/02/01.☆111Updated last month
- Port of my M5Stack Core 2 audio monitor project to generic ESP32s with TFT screens☆72Updated 2 years ago
- TcMenu modular IoT menu library supporting rotary encoder, joysticks, many displays, and remote control over Ethernet and Serial☆117Updated 5 months ago
- Single-Cell Li-Ion, LiPo and LiFePO4 Battery Capacity Tester☆28Updated 2 years ago
- DIY portable Wi-Fi enabled signal generator☆42Updated 5 years ago
- Extracting the ESP32 ADC reference voltage to improve ADC reading accuracy☆39Updated 2 years ago