prempalsingh / cansat-xbee
Plotting realtime data from XBee for Cansat competition
☆11Updated 9 years ago
Alternatives and similar repositories for cansat-xbee:
Users that are interested in cansat-xbee are comparing it to the libraries listed below
- Ground Station System, CanSat On board Telemetry with GY-80, Arduino and Xbee☆15Updated 11 months ago
- Flight Controller Firmware☆10Updated 4 years ago
- OBC hardware for UPSat☆29Updated 6 years ago
- SUCHAI Cubesat flight software☆21Updated 7 years ago
- A repo for introduction of GNSS☆12Updated 4 years ago
- Broadcast NMEA 0183 data over Wi-Fi using the ESP8266☆19Updated 2 years ago
- Payload board schematic and footprint for the SUCHAI 2 and 3.☆14Updated 2 years ago
- 3D-printable reaction wheel capable of active detumbling and attitude control.☆18Updated 4 years ago
- An autonomous Thrust Vector Control rocket with self-landing capability from inexpensive parts of equivalent power of the Apollo era.☆55Updated 3 years ago
- Code and files for the Arduino DIY Satellite project (Cubesat)☆38Updated 5 years ago
- Design discussions, engineering justifications, and qualification data☆28Updated 3 years ago
- ☆68Updated 8 years ago
- ESP32-based LoRa ground station☆30Updated 4 years ago
- Remote robot using STM32, ESP8266 and Android☆14Updated 2 years ago
- RTTY and LoRa High Altitude Balloon Tracker for Arduino and SX127x☆31Updated last year
- Eagle files and current software for TT7F high altitude balloon tracker.☆11Updated 7 years ago
- Arduino port of the dAISy AIS project for si446x☆17Updated 6 years ago
- VHDL codes to generate GPS L1 C/A and Galileo E1OS and E5 PRNs and dataless signals. Secondary codes not included.☆28Updated 6 years ago
- Transparent UART to UART Bridge using ESP8266☆11Updated 2 years ago
- Arduino Data Logger for Volt and Ampere and two additional analoge signals☆16Updated 9 years ago
- Open source SDR + COTS GPS board provides I and Q data plus COTS binary data over Ethernet.☆47Updated 6 years ago
- MPU6050 reading and plotting with python☆9Updated 2 years ago
- APRS TNC Decoder and OLED display☆10Updated 6 years ago
- Code for a CanSat or OBCs GUI ground station where different sensor data are displayed in real time. No sensors needed to try it.☆120Updated 2 years ago
- RF powermeter with USB-interface☆14Updated 2 years ago
- The PC/104 FlatSat used for the development and testing of the CubeSat MOVE-II☆19Updated 5 years ago
- Trackuino firmware source code☆10Updated 6 years ago
- AMSAT Fox-1 satellite Maximum Power Point Tracker hardware design files☆61Updated 3 years ago
- Opensat first generation cubesat bus, launch into orbit at 2016/11/11☆34Updated 2 years ago
- Reports on the tests carried out on the SX1280 LoRa device☆56Updated 4 years ago