polihedron / DIY-Reflow-OvenLinks
DIY Reflow Oven, mcu: STM32F103 dev board, Display: Nextion Basic 3.5", PID controller.
☆37Updated 3 years ago
Alternatives and similar repositories for DIY-Reflow-Oven
Users that are interested in DIY-Reflow-Oven are comparing it to the libraries listed below
Sorting:
- Reflow controller with ESP32 and TFT LCD on board.☆68Updated 2 months ago
- Pendants for controlling FluidNC CNC firmware☆43Updated 4 months ago
- ☆29Updated 3 years ago
- A low cost stepper motor analyzer that uses wireless BLE link to display the data in real time on a Windows/Mac/Linux PC.☆54Updated last year
- Open source pick and place machine☆25Updated 11 months ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆53Updated 4 years ago
- Low-cost and simple GRBLHAL to MACH3 BOB bridge for Raspberry Pi Pico☆27Updated 5 months ago
- Multi-sensor intelligent environmental Monitor☆17Updated last year
- Automated device to apply solder paste onto a PCB without using a stencil.☆11Updated 3 years ago
- PNPASSIST: A “SMART” BUILD PLATFORM FOR MANUAL PCB ASSEMBLY☆43Updated 3 years ago
- ESP8266 reflow controller☆24Updated 2 years ago
- A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)☆25Updated 4 months ago
- 3D printer control board based on ESP32,support 8 Driver motors.☆80Updated 2 years ago
- 0816 SMT Automatic Feeder modified to work with the OpuloPNP. Custom firmware written for an arduino nano with a servo sheild can run 12 …☆15Updated 3 years ago
- tape puller/remover for 0816 automatic feeder☆21Updated 6 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆77Updated 2 weeks ago
- Bluetooth LE temperature controller for the 946C electronic hot plate☆111Updated last year
- All documents about making microsmt pnpboard☆57Updated this week
- List of controllers supported by grblHAL☆52Updated 5 months ago
- DIY Electronic load for DCDC converter characterization☆50Updated 4 years ago
- Firmware for the 0816 automatic 3d printed smt feeder for OpenPnP.☆34Updated 3 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- Is it magik? Or is it just a 3d printed box for holding your solder stencils with automatic lifting and vacuum hold down?☆34Updated 3 years ago
- The repo contains the design for converting the 3d printer to pick and place machine☆38Updated 3 months ago
- Battery Health Monitor A compact device for monitoring the State of Health (SoH) and State of Charge (SoC) of lithium batteries. It uses …☆28Updated 4 months ago
- A Pendant for FluidNC CNC Firmware☆63Updated 2 weeks ago
- SmartPendant - a way to control grblHAL based CNC machine without PC☆58Updated 3 weeks ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆126Updated 3 years ago
- Single-Cell Li-Ion Battery Charger with Monitoring☆63Updated 2 years ago
- An STM32F4-based 3D printer control board, designed to be fast, quiet, and compact.☆22Updated 6 years ago