olliw42 / digaustrackingLinks
360° gimbal target tracking system
☆13Updated 8 years ago
Alternatives and similar repositories for digaustracking
Users that are interested in digaustracking are comparing it to the libraries listed below
Sorting:
- PPM Encoder board http://paparazzi.enac.fr/wiki/ATmega_PPM_Encoder_Board☆31Updated 13 years ago
- CC2500 Radio Library☆22Updated 11 years ago
- Open Source 3 Axis Board Design files☆90Updated 11 years ago
- Firmware for Solo ESC REV2 - Based on SimonK firmware☆9Updated 9 years ago
- STM32 32-bit microcontroller based UAVCAN nodes for DIY☆78Updated 5 years ago
- Neato XV-11 LIDAR connected to an STM32F429IDISCOVERY board for 360-degree range scanning and measurement☆41Updated 10 years ago
- FPV antenna tracker based on a STM32F4 Discovery board and a pololu style servo motor☆30Updated 5 years ago
- MinimOSD firmware for OpenPilot/LibrePilot CC/CC3D/Atom/Revolution/Revo Nano, MAVLink (APM/Pixhawk PX4/Paparazzi/generic MAVLink), GPS u-…☆45Updated 7 years ago
- UAVCAN is a lightweight protocol designed for reliable communication in aerospace and robotic applications via CAN bus.☆36Updated 3 years ago
- Controller code for a camera stabilizing gimbal using an Ardunio Due, two MPU-6050 IMUs, and three L6235 3-phase brushless motor controll…☆11Updated 8 years ago
- tinyPEPPER2 4in1 ESC☆27Updated 7 years ago
- OpenBLDC Strip (STM32F103)☆67Updated 8 years ago
- ☆27Updated 7 years ago
- Arduino based USB Linker protocol☆62Updated 6 years ago
- A small Converter to convert Futaba SBus to PPM or Spektrum-Serial☆42Updated 9 years ago
- BLDC ESC firmware (GPLv3.0)☆49Updated 4 years ago
- Brushed motor firmware for Brushless ESCs☆28Updated 4 years ago
- 9 DoF sensor fusion with AHRS output for MPU-6050 gyro/accel + HMC5883 magnetometer sensor☆30Updated 3 years ago
- CC3D and STM Cube based CableCam controller☆41Updated 5 years ago
- ☆63Updated 3 years ago
- stm32 rf with nrf24l01☆9Updated 10 years ago
- ESC32☆13Updated 12 years ago
- Research on Frequency-Hopping Spread Spectrum protocol with NRF24L01☆17Updated 4 years ago
- A Graphical OSD for FPV☆68Updated 9 years ago
- The DieBieMSTool can be used to configure the DieBieMS. More documentation will follow.☆35Updated 5 years ago
- ☆46Updated 7 years ago
- UAVCAN for STM32 Arduino☆42Updated 5 years ago
- Arduino code for STM32 microcontrollers☆61Updated 7 years ago
- Zubax GNSS module☆55Updated 10 months ago
- Arduino PPM signal reader/decoder Library☆41Updated 3 years ago