oleksiikutuzov / IKEA-VINDSTYRKALinks
My findings about this sensor
☆136Updated 2 years ago
Alternatives and similar repositories for IKEA-VINDSTYRKA
Users that are interested in IKEA-VINDSTYRKA are comparing it to the libraries listed below
Sorting:
- Alternative firmware for wireless 433MHz door/window reed sensors triggered by magnetic contacts.☆158Updated last year
- Ramblings regarding the IKEA VINDSTYRKA and its sensor implementation☆48Updated 2 years ago
- ☆88Updated 3 months ago
- ☆96Updated last year
- A WiFi connected mail notifier using an ESP8285 module and Telegram☆85Updated 2 years ago
- Arduino C++ Library and interface to flash the ZBS243 / SEM9110 8051 Microcontroller☆148Updated 11 months ago
- An all-in-one remote based on the ESP32-WROOM-32E☆140Updated 4 months ago
- Hardware and Software for a Raspberry UPS based on an ATTiny☆65Updated 2 years ago
- ☆235Updated last year
- Anotter OSHW environment sensor hub, focussed on Sensirion SEN055/SEN05x sensors, featuring a prometheus-exporter.☆101Updated 2 years ago
- Arduino Repository for an E-Ink CO2 Sensor using ESP32 and SCD4X☆119Updated this week
- Home Climate Control Core: *the* Open Source multi-zone temperature and climate control system.☆65Updated this week
- ☆59Updated this week
- A water detector to prevent flooding that runs on LiPO batteries and transmits its status and notifications via MQTT☆69Updated 6 years ago
- IoT smart gas meter gets your home gas consumption nicely charted on a web page. Build your own for less than 10€☆55Updated 2 years ago
- This is the wall charger mount version☆85Updated last year
- ☆146Updated 3 months ago
- Raspberry Pi Pico Home Automation using CAN Bus☆89Updated 2 years ago
- Homekit to RV-C bridge - Allows control of RV lights, fans, and thermostats via HomeKit.☆79Updated 11 months ago
- Smart controller for IKEA Uppåtvind Air Purifiers☆52Updated 2 years ago
- Open source heat pump controller and home automation terminal, built on ESP32☆85Updated last year
- ESPHome configuration for a DIY indoor air quality monitor for CO₂ concentration, PM2.5 and PM10 concentrations, and temperature, humidit…☆104Updated last year
- ☆126Updated 2 years ago
- A Python based open source viewer for the NE3 Earpick wireless endoscope☆92Updated last year
- TI CC2652R w/ USB-UART in the ubiquitous "stick" form factor☆83Updated 4 years ago
- USB to serial adapter with built-in ESP32 auto-reset circuitry☆73Updated last year
- Firmware of open-source hardware air quality monitors AirGradient ONE (indoor) and AirGradient Open Air (outdoor).☆281Updated 3 weeks ago
- ESP32 IOT light switch that will be tiggerable via MQTT, web interface and of course the button☆54Updated last year
- The Smart Powermeter is powered by a ESP32-S2, allowing the measurement up to 6 CT clamps for reading electric current and real-time disp…☆90Updated 2 months ago
- All about the MicroWakeupper Library (and BatteryShield for the Wemos D1 Mini)☆41Updated last year