nickshl / RoombaChargeLimiterLinks
Project of device that allow to use lithium batteries in Roomba without Charging Error 5
☆24Updated 5 years ago
Alternatives and similar repositories for RoombaChargeLimiter
Users that are interested in RoombaChargeLimiter are comparing it to the libraries listed below
Sorting:
- Library for working with JBD BMS☆76Updated last year
- ☆11Updated 3 years ago
- This is V4 of the Arduino Spot Welder. An Arduino based Spot Welder for battery welding☆98Updated 8 months ago
- Code and schematics for driving a Nixie tube clock with a NodeMCU 1.0 ESP8266 development board☆57Updated 6 years ago
- A guide to install Octoprint on the Creality WiFi Box or similar OpenWrt devices☆81Updated last year
- Kiln PID controller based on Espressif Systems ESP32 chip board with Arduino IDE.☆157Updated last year
- ESP32 DIY Digital Readout☆109Updated 6 years ago
- Simple library for Arduino (ESP32) to control a Chinese diesel heater through 433 MHz RF☆105Updated 5 years ago
- Camera print monitor for Marlin-based 3D Printers☆40Updated 5 years ago
- KiCad symbol and footprint for the ESP32 Mini, the ESP32 clone of the Wemos D1 mini with more pins and more power!☆104Updated 4 years ago
- The closed-loop drive is to feedback the rotation angle of the stepping motor to the control panel, compare the distance that needs to be…☆21Updated 2 years ago
- ☆20Updated last year
- The Valden Heat Pump controller is a platform to precisely control heat pumps☆151Updated 4 years ago
- My mods for DumboRC DDF-350 RC remote firmware(s)☆22Updated 3 months ago
- ESPHome component to monitor and control some Atorch meters via bluetooth☆87Updated last month
- DIY WiFi Filament dryer☆172Updated last year
- Optimized firmware for RepRap 3D printers based on the Arduino platform.☆20Updated 7 years ago
- Information gathered on the Uni-T UT210E multimeter.☆175Updated 2 years ago
- Simple control and status paired with a physical button panel and OLED display☆60Updated 2 years ago
- ☆41Updated 2 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆77Updated last year
- ☆89Updated 3 months ago
- 150W Electronic load / Battery discharge capacity tester PX-100 v2.70 protocol and control software. May be compatible with some DL24 ver…☆126Updated last year
- Cura Plugin that lets you use a HID mouse to pan/rotate/zoom the view☆100Updated last year
- Better Grbl Support Plugin for Octoprint based (loosely) on the original Grbl Support plugin developed by mic159☆71Updated this week
- to streamline the install or upgrade of KLIPPER & DWC2 front-end for it. With these 2 together no need to use octoprint. I run mine on or…☆56Updated 5 years ago
- Extend the possibilities of cheap digital power supplies with a WiFi module☆59Updated last year
- Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin inst…☆34Updated last year
- BeeGl☆13Updated 5 years ago
- YardForce GForce Mainboard RE☆20Updated 2 months ago