mgerstgrasser / tc4plus-coffee-roaster-shieldLinks
The TC4+ is improving and expanding on the TC4 Arduino shield for DIY (and commercial) coffee roasters.
☆22Updated 6 years ago
Alternatives and similar repositories for tc4plus-coffee-roaster-shield
Users that are interested in tc4plus-coffee-roaster-shield are comparing it to the libraries listed below
Sorting:
- ☆88Updated 7 months ago
- A Grbl_ESP32CNC Controller for MPCNC☆88Updated 3 years ago
- A powerful 32-bit 3D printer control board.☆72Updated 5 years ago
- Yet another arduino controlled coffee roaster project☆59Updated 5 years ago
- ☆66Updated 5 years ago
- grbl controller for esp32☆196Updated 2 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆76Updated last year
- WebSocket to Serial bridge for LaserGRBL☆73Updated 7 years ago
- faceless clock☆54Updated 7 years ago
- ☆207Updated 4 months ago
- A wireless GRBL CNC pendant project based on the ESP32 micro-controller☆53Updated 4 years ago
- 4 Axis CNC Controller for Grbl_ESP32☆66Updated 5 years ago
- ESP32-based 3D printer controller☆125Updated 4 years ago
- ☆75Updated 3 years ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆126Updated 3 years ago
- A temperature profile controller for roasting coffee, using the Teensy 3.5 development board.☆41Updated 6 years ago
- Multiple compiled versions for different boards & machines (under releases)☆58Updated 3 years ago
- tape puller/remover for 0816 automatic feeder☆21Updated 6 years ago
- Lixie II - Open Source Hardware files!☆41Updated 4 years ago
- grblHAL driver for ESP32☆102Updated this week
- A small 3D printer controller board for use with a "blue pill" STM32F1 generic board. Inspired on http://reprap.org/wiki/SinapTec☆76Updated 5 years ago
- grbl 0.9i with Servo Motor support and CoreXY configuration Used For Crazy Engineer's Drawing Robot☆89Updated 6 years ago
- Schemetics and Code for a DIY weller soldering station☆157Updated 8 years ago
- CNC xPRO Driver (4x DRV8825 motor drivers; dual motor confiurations on X,Y, or Z axis + wireless support☆34Updated 7 years ago
- The RAMPS 1.6 is the second RAMPS iteration released by BIGTREETECH. It replaces the original green power connector with a pair of screw …☆91Updated 5 years ago
- Z-height sensor board add-on for RepRapPro Ormerod 3D printer☆103Updated 8 years ago
- FYSETC Board - The E4 board is a minimal 3D printer control board based on the ESP32 microcontroller from ESPRESSIF, with built-in Wi-Fi …☆68Updated 4 months ago
- ☆43Updated 8 years ago
- The hakko T12 digital controller on atmega328☆67Updated 4 years ago
- A CNC controller to use and test Grbl_ESP32☆78Updated 4 years ago