malnvenshorn / OctoPrint-MetadataPreprocessorLinks
This OctoPrint plugin reads a generated metadata block in the gcode file to speed up the analyzing process on systems with limited resources like the Raspberry PI.
☆10Updated 2 years ago
Alternatives and similar repositories for OctoPrint-MetadataPreprocessor
Users that are interested in OctoPrint-MetadataPreprocessor are comparing it to the libraries listed below
Sorting:
- Combining 3d printed and metal parts to build an open source motorized dslr slider.☆17Updated 3 years ago
- OctoPrint-Plugin☆12Updated 5 years ago
- ☆37Updated 3 years ago
- Plugin for Cura to make debugging settings problems much easier.☆12Updated 3 years ago
- A hardware remote for Octoprint controlled 3D Printers☆22Updated 7 years ago
- Adds RGB LED support to OctoPrint with the ability to choose effects based on the current status of your printer☆34Updated 4 years ago
- OctoPrint plugin to display the estimated print cost for the loaded model☆24Updated 5 years ago
- Firmware for Replicape☆37Updated 3 years ago
- Linux distro for 3D-printers☆28Updated 2 years ago
- Automatically heat printhead to the printing temperature of the current gcode file☆36Updated 4 years ago
- ESP32 DIY Digital Readout☆109Updated 6 years ago
- Interactive temperature graph for octoprint☆19Updated 4 years ago
- Arduino/Marlin firmware flasher for OctoPrint☆40Updated last year
- Pause print on GPIO sensor☆25Updated 7 years ago
- ☆44Updated 2 years ago
- Firmware for Original Prusa i3 3D printer by PrusaResearch☆12Updated 7 years ago
- Plugin for OctoPrint - saves filename, print time and filament usage for each print☆64Updated last year
- ☆24Updated 7 months ago
- This repository contains all the files needed to rebuild our 3Dator 3D printer.☆23Updated 8 years ago
- Slic3r plugin for slicing within OctoPrint☆96Updated 3 years ago
- An OctoPrint plugin to view current CPU and RAM usage☆42Updated last year
- Post processors for grblHAL and Grbl☆14Updated last year
- ☆22Updated last year
- ESP8266 as generic network interface over UART☆17Updated last year
- CuraOrientation plugin is a simple wrapper around the STL-tweaker.☆51Updated 8 months ago
- OctoPrint-Plugin☆10Updated 4 years ago
- PIDflight Lap Timing device firmware☆10Updated 5 years ago
- Pendants for controlling FluidNC CNC firmware☆44Updated 9 months ago
- Klapper is a free, open-source and not Vue-based Klipper web interface for managing your 3d printer.☆10Updated 2 years ago
- An OctoPrint Plugin that adds support for MQTT.☆166Updated last year