joshbrew / HEG_ArduinoLinks
OUTDATED, FIND MY ESP32 REPO AT https://github.com/moothyknight/HEG_ESP32 -- A DIY instruction set and rough program to run an HEG off an Arduino Nano. It uses an IR and Red LED, an OPT101 sensor, an ADS1115, and an Arduino Nano V3. The HEG is basically a pulse oximeter for your cortex, but allows for biofeedback and direct control.
☆20Updated 6 years ago
Alternatives and similar repositories for HEG_Arduino
Users that are interested in HEG_Arduino are comparing it to the libraries listed below
Sorting:
- A single lead ECG heart-rate variability monitoring patch with ESP32☆138Updated last year
- Firmware for my ESP32-based hand-rolled LWIR camera device☆50Updated 7 years ago
- Breakout board for the Maxim MAX3003 single-channel ECG AFE☆45Updated 3 months ago
- ☆66Updated 4 years ago
- A surprisingly good ECG circuit using a single op-amp and some Python software☆108Updated 4 years ago
- Driver for MAX30100 using arduino☆106Updated 6 years ago
- ProtoCentral MAX86150 PPG and ECG chip breakout board Arduino libraries and Hardware☆39Updated 8 months ago
- A library for the Maxim MAX30100 pulse oximetry chip☆37Updated 8 years ago
- ESP32 Thing-compatible board using the WROOM module and a QWIIC connector.☆20Updated 2 years ago
- Super low cost GPS navigation system based on Arduino UNO, 320x240 TFT and GPS unit☆28Updated 10 years ago
- Developer board for the Esp32-S2 chip from Espressif. Provides both USB interfaces: native and Uart bridge.☆17Updated 5 years ago
- An ESP32 project using two linear stepper motors and a burning laser diode☆61Updated 4 years ago
- Hardware and software for the Arduino Zero☆41Updated 6 years ago
- an easy way to build your own walkie talkies!☆38Updated 9 years ago
- A versatile wireless monitoring device that combines ECG, impedance pneumography, photoplethysmography, SPO2 calculation, galvanic skin r…☆21Updated 8 years ago
- FemtoBeacon - Atmel SAM R21 (ARM Cortex M0+, SAM D21 with built in AT86RF233)☆66Updated 5 years ago
- Sparklines 📉📈 for ESP8266, ESP32 – Should work with other Arduino-supported controllers☆96Updated 4 years ago
- PIDDYBOT is an Open Source Balancing Robot with the aim of teaching PID control.☆43Updated 8 years ago
- Nano-Sized ATtiny85 devboard with USB Bootloader☆90Updated 9 years ago
- HEGduino with ESP32: Hemoencephalography meets highly affordable IoT!☆90Updated 2 years ago
- Based off of the CoinCell Board but with more sensors and a 80x160 ST7735 color tft lcd☆58Updated 4 years ago
- uECG - very small wearable ECG device that sends raw and processed data over BLE☆73Updated 4 years ago
- Esp32-S2 dev board with 240x240 IPS display☆80Updated 4 years ago
- Cordwood-style blinky ring, powered by an ATtiny85 and a pair of size 10 Zn-air hearing aide batteries.☆39Updated 7 years ago
- ESP32 IoT board with 4MB external RAM, 4MB external Flash, LiPo charger, external crypto engine USB-OTG☆51Updated last year
- Feather-sized SAMD51 with M4 core serving as UART bridge to WROOM ESP32☆42Updated 4 years ago
- Firmware for the Silver open-source, long-range camera remote control☆15Updated 5 years ago
- PIXO Pixel is a 16 x 16 RGB LED display that runs off of an ESP32☆65Updated 7 years ago
- Material for video #149☆84Updated 5 years ago
- CDM324 Amplification Backpack, With Case and Simulations☆62Updated 8 years ago