johnjore / KalaLinks
Xamarin.Forms based client for openHAB 2
☆11Updated 2 years ago
Alternatives and similar repositories for Kala
Users that are interested in Kala are comparing it to the libraries listed below
Sorting:
- RedMatic based Homematic UI☆15Updated 6 years ago
- ESP8266 based bidirectional bridge between MQTT and IR (change MQTT message to IR signal and change received IR signal to MQTT message)☆145Updated 4 years ago
- JavaScript utilities and examples for using Grafana with openHAB☆47Updated 2 years ago
- An openHAB integrated kiosk browser☆70Updated 3 years ago
- Home Automation Room Controller☆46Updated 9 years ago
- Alternative Firmware for 'ESP8266, ESP8285 and ESP32 based devices' like Itead Sonoff, Shelly or NodeMCU, with Web, Timers, OTA, MQTT, KN…☆46Updated last year
- Python script for sending/receiving commands to/from GPIO pins via MQTT messages☆46Updated 5 years ago
- ESP8266 Momentary Switch with MQTT☆12Updated 7 years ago
- Fhem module for snips.ai☆13Updated 6 years ago
- Pimatic plugin for Amazon's dash-buttons☆14Updated 6 years ago
- FHEM Module For ESPEasy☆15Updated 8 years ago
- Node.js based Interface between Homematic and MQTT☆21Updated 6 years ago
- A Node-RED contrib-node that emulates a thermostat☆21Updated 4 years ago
- The ultimate Domotic web remote for the rest of us. A web frontend for Home automation software like Domoticz, OpenHab, Domotiga, etc...☆34Updated last year
- Pimatic plugin for using 433mhz devices and sensors with a connected Arduino with homeduino sketch☆36Updated 5 years ago
- Irrigation controller using Openhab and the ESP8266 module☆22Updated 9 years ago
- Use KNX just like the mqtt nodes☆20Updated 5 years ago
- A Node-RED node to monitor home appliances based on their power consumption.☆21Updated last year
- HomeMatic Funk-Komponenten im Eigenbau☆33Updated last year
- OHScheduler is a HABPanel widget that simulates a scheduling interface for Virtual Thermostats and On/Off appliances.☆13Updated 6 years ago
- ESPEasy Plugins☆15Updated 7 years ago
- Control your Homematic devices using Node-Red☆18Updated 4 years ago
- Gateway for Loxone™ miniserver to communicate with mqtt broker☆27Updated 5 years ago
- A python based service that receives sensor inputs and publishes them in various ways.☆106Updated last month
- Insert incoming MQTT values into InfluxDB. Follows mqtt-smarthome architecture.☆38Updated 4 years ago
- AngularJS-based dashboard-like interface for ioBroker (based on openHAB panel)☆23Updated this week
- ☆21Updated 6 years ago
- Opensource Repository of SmartPi☆65Updated this week
- KNXnet/IP server for KNX IP, KNX (RF) USB, FT1.2, and TP-UART☆61Updated last week
- Monitor Bluetooth Low Energy beacons☆44Updated 4 months ago