jcrocholl / recirculating
Prototype for 3D printable linear motion carriage with recirculating Delrin/Nylon balls, for use with OpenBeam.
☆68Updated 10 years ago
Alternatives and similar repositories for recirculating:
Users that are interested in recirculating are comparing it to the libraries listed below
- A ful metal CoreXY system for 3D printer, mill etc..☆47Updated 10 years ago
- Force-Sensitive Resistor controller designed for Delta 3D printers for automatic bed leveling☆56Updated 2 years ago
- RepRap version of Zelogik's core-XY 3D printer☆83Updated 5 years ago
- Arduino-compatible library to configure the Trinamic TMC2130 stepper motor driver☆42Updated 6 years ago
- the simple and cheap corexy from smartfriendz☆65Updated 8 years ago
- servo-controlled reprap 3D printer☆98Updated 9 years ago
- Marlin Delta firmware with autocalibration updates☆139Updated 9 years ago
- Delta robot 3D printer.☆212Updated 12 years ago
- Kossel 250 V-Slot☆40Updated 6 years ago
- ☆149Updated 10 years ago
- Reprap FW with look ahead. SDcard and LCD support. It works on Gen6, Ultimaker, RAMPS and Sanguinololu☆173Updated 8 years ago
- Reprap FW with look ahead. SDcard and LCD support. It works on Gen6, Ultimaker, RAMPS and Sanguinololu☆38Updated 7 years ago
- 📟 MK 3D Printer Firmware for Arduino☆52Updated 7 years ago
- Electronic boards compatible with Arduino☆129Updated 7 years ago
- M Prime One is an open, low cost and easy to use 3D printer☆67Updated 8 years ago
- MKS SBASE is a powerful 32-bit 3D printer control board with LPC1768. Support Marlin2.0, Smoothieware. Support MKS LCD12864 and MKS TFT T…☆157Updated 3 years ago
- This is part of the RepRap project, see http://www.reprap.org. Gen7 is the next generation of electronics meant to drive a RepRap machine…☆131Updated last year
- Simulates stepper motor driver systems☆103Updated 7 years ago
- Deprecated: use http://github.com/openhardwarecoza/LaserWeb3 instead☆41Updated 8 years ago
- Firmware for TFT control panel for Duet electronics☆40Updated 4 years ago
- 3D Printable 3:1 Geared Extruder☆84Updated 4 years ago
- Portable, Accurate, Open Source 3D Printer☆51Updated 6 years ago
- Update to Eustathios with a little bit of HercuLien Design Changes☆112Updated 4 years ago
- All the mechanics of the BCN3D Sigma 3D Printer.☆101Updated 7 years ago
- Open Source Delta Automatic Calibration Tool☆54Updated last month
- G3 Firmware for the Mighty Board motherboard used in The Replicator.☆74Updated 4 years ago
- ☆74Updated 2 years ago
- the easy to build reprap☆126Updated 7 years ago
- Open Exposer - Hardware, Slicer, Host, Firmware☆67Updated 8 years ago
- The Sienci Mill One is an open source machine made by Sienci Labs that turns your ideas into reality by carving 3D objects from materials…☆23Updated 7 years ago