flyonspeed / OnSpeed-Gen2
OnSpeed Gen2 - AOA aural indicator for flying "On Speed" with onboard sensors
☆26Updated 10 months ago
Alternatives and similar repositories for OnSpeed-Gen2:
Users that are interested in OnSpeed-Gen2 are comparing it to the libraries listed below
- CanFly public display code☆25Updated 8 months ago
- Arduino software for AHRS module☆16Updated 3 years ago
- Expermental Aircraft Glass Cockpit☆22Updated 5 years ago
- AHRS Display for the Raspberry pi powered Stratux software☆20Updated 2 years ago
- GDL 90 decode/encode tools and libraries☆53Updated 3 months ago
- Arduino script for EMS sensor board☆8Updated 3 years ago
- Engine monitoring for experimental aircraft on your tablet for about $150☆24Updated 6 years ago
- Electronic Flight Information System in Python☆63Updated 2 months ago
- Flight Information Glass Panel for Tablet and Smartphone☆14Updated 3 years ago
- Display for Stratux Europe Edition, can run standalone☆39Updated this week
- A Raspberry Pi knock off of the Dynon D2 artificial horizon that leverages the stratux project.☆21Updated 9 years ago
- Stratux is an open-source, DIY avionics system offering affordable ADS-B and flight data, enhancing situational awareness for general avi…☆190Updated last week
- Multiprotocol antenna tracker and ground osd.☆144Updated 6 years ago
- Display EFIS flight data or any type of sensor data on screen or AR glasses. Designed for Raspberry Pi and MacOS. Garmin G3x, MGL, Dynon,…☆28Updated this week
- RemoteID support using OpenDroneID☆116Updated 5 months ago
- OGN Tracker implementation on ESP32 devices☆59Updated last year
- vSpeed Vario - DIY Paragliding Variometer☆35Updated 4 years ago
- Stratux Europe on a Pi3, Pi4, Pi5 or Pi Zero 2 W based on a fresh 64bit RasPiOS Image☆20Updated this week
- Heads Up Display for use with Stratux. Designed for reflective HUD screens, intended for traffic call outs.☆126Updated last week
- This repository Garmin G5 AI + HSI in dual stack mode. This model interfaces with X-Plane flight simulator and intends to run on a 7 inch…☆26Updated 9 months ago
- OpenIVario Wiki:☆62Updated this week
- UAT (ADS-B 978) test signal generator☆47Updated 4 years ago
- Arduino based variometer with accelerometer, screen, gps and sdcard code☆90Updated 4 years ago
- Library to control UBX binary protocol and NMEA over I2C on Ublox GPS modules☆145Updated 4 years ago
- Arduino Sketch for converting FrSky S.Port telemetry data to MAVLink format☆19Updated 5 years ago
- The fastMavlink library.☆68Updated 6 months ago
- Cheap DIY RC link based on LoRa 868MHz modules☆118Updated 6 years ago
- Arduino software for the Display module☆12Updated last year
- An opendroneid / ASTM F3411 / EN 4709-002 UAV remote ID using Bluetooth 4 & 5 for nRF52 processors.☆18Updated last year
- Multifunctional, compatible DIY aviation proximity awareness, variometer and messaging system with FANET+, FLARM and OGN support.☆132Updated last week