fazjaxton / CANLinks
This library is intended for use with the FazCAN shield for Arduino and the Arduino 1.0 (or later) development environment.
☆15Updated 10 years ago
Alternatives and similar repositories for CAN
Users that are interested in CAN are comparing it to the libraries listed below
Sorting:
- SparkFun Low Current Sensor Breakout Board - ACS712☆18Updated 7 years ago
- Do it Yourself through hole boards☆12Updated 8 years ago
- A CANBus Triple clone based on the Espressif ESP32 SoC☆18Updated 9 years ago
- Library to facilitate CAN functionality with the onboard MCP2515 CAN controller☆46Updated 7 years ago
- Serial Wire Debug (SWD) implementation for Particle devices☆21Updated 6 months ago
- Mini Ultra Pro - Arduino Compatible 32-bit ARM Cortex M0+ Board☆19Updated 3 years ago
- Arduino OneWire DS2438 device library.☆20Updated 7 years ago
- Arduino library for the SI1145 sensors in the Adafruit shop☆22Updated last year
- Eagle CAD files for CANBus Triple Hardware☆56Updated 8 years ago
- ☆28Updated 14 years ago
- RFM12B to Raspberry Pi board☆22Updated 4 months ago
- Code and Documents for NodeMCU based relay board☆31Updated 7 years ago
- circuit for a minimal EVSE for charging an electric vehicle with the J1772 standard☆11Updated 9 years ago
- Charge LIR2560 coin cells via USB. Based on MCP73831☆13Updated 10 years ago
- ☆26Updated last week
- Library for Arduino IDE to send AT or ASCII commands via UART☆48Updated 4 years ago
- KiCad libraries used by my projects☆13Updated 2 years ago
- SparkFun LiPo Fuel Gauge☆26Updated 2 years ago
- PID temperature control for oven and/or electric heater, using Arduino☆22Updated 2 years ago
- Firmware library for the MAX17043 LiPo fuel gauge IC - used on SparkFun's Photon Battery Shield.☆15Updated 5 years ago
- Repository for sharing my open-source Arduino code☆132Updated 6 years ago
- Get statistics from your Omnik solar inverter☆16Updated 2 years ago
- CAN-Bus Shield for Arduino based on Microchip MCP2515 or MCP2517FD CAN Controller☆27Updated 5 years ago
- Driver for Adafruit's SPI-Based FRAM Breakouts☆36Updated last year
- Arduino Software for RS485 support with collision detection and message handling capabilities☆113Updated 7 years ago
- A protocol agnostic library for HopeRF's RFM69 modules and STM32 controllers☆67Updated 8 years ago
- Multiplatform Arduino library for supporting the native CAN controller on Due (SAM3X) and Teensy 3.1 (K2X) as well as MCP2515 through SPI☆95Updated 7 years ago
- Wireless programming library and example code for Moteino☆40Updated 3 weeks ago
- foxBMS Hardware☆11Updated 8 years ago
- A library for RAiO RA8875 display driver for Teensy3.x or LC/Arduino's/Energia/Spark☆83Updated 5 years ago