faithanalog / pagerencLinks
Haskell FLEX/POCSAG page encoder for multimon-ng consumption
☆14Updated 6 years ago
Alternatives and similar repositories for pagerenc
Users that are interested in pagerenc are comparing it to the libraries listed below
Sorting:
- send pocsag messages inside RF22 on si4432-based ISM modules☆40Updated 11 years ago
- This is an Open-Source implementation of the FLEX paging protocol encoder.☆37Updated 2 years ago
- pocsag library for arduino + demo application for si4332 RF modules☆80Updated 11 years ago
- Arduino library with LCD, Keyboard and SPI Flash support for the SMART Response XE classroom communicator☆101Updated 2 years ago
- Arduino based pocsag decoder☆14Updated 8 years ago
- Experimental software-defined radio using a serial port☆80Updated 6 years ago
- ☆34Updated 11 years ago
- Send sketches wirelessly from the Arduino IDE to your SMART Response XE☆37Updated 7 years ago
- For Nano Serial Duplex hotSPOT UserGuide☆11Updated 7 years ago
- Firmware and programmer to re-flash the UV3R radio☆94Updated 12 years ago
- Adding a CC1101 module to SRXE☆124Updated 6 years ago
- Expansion board for Raspberry PI allowing to use coaxial SMA output instead of direct wire connection to GPIO to connect radio equipment …☆35Updated last month
- ☆24Updated 2 years ago
- STM32 & SI4032 rtty test☆17Updated 9 years ago
- A SDR PCB project base on msi2500 and msi001☆61Updated 4 years ago
- The Nucleo TNC is a breadboard implementation of the Mobilinkd TNC3 using a STM32L432KC Nucleo32 board. This TNC faithfully implements th…☆106Updated 2 years ago
- General purpose firmware for MicroModem with forward error correction and larger packet sizes☆66Updated 7 years ago
- A modem/TNC to generate the AFSK audio tones for sending APRS messages using a Raspberry Pi Pico/Pico2☆50Updated last month
- SC14CVMDECT DEVBOARD☆18Updated 9 months ago
- Firmare to turn a SMART Response XE into a serial terminal. https://hackaday.io/project/180910-smart-response-xe-linux☆35Updated 3 years ago
- A FreeDV device based on the ESP32.☆106Updated last year
- why?☆10Updated 5 years ago
- TNC for Raspberry Pi Pico☆77Updated 5 months ago
- Arabell300 is an Arduino-based 300 baud modem implementing Bell 103 and ITU V.21 standards. Features Hayes-compatible AT commands, AFSK…☆26Updated 5 months ago
- V.23 Softmodem for Asterisk with some Bildschirmtext-specific stuff in it.☆69Updated 7 years ago
- RTL-SDR as RTTY transceiver☆37Updated 9 years ago
- SMART Response XE based pagers for the 503 Party 2019☆16Updated 6 years ago
- Fork of https://github.com/aa1gd/pico_ft8_xcvr project from AA1GD. Real-time FT8 decoding on Raspberry Pi Pico.☆26Updated 3 years ago
- OpenBCM - BCM for everybody (packet radio mailbox system initiated by DL8MBT)☆14Updated last week
- Encode pocsag messages to dump to a file☆37Updated last year