euphy / AccelStepperEncoderLinks
A subclass of Mike McCauley's excellent AccelStepper library (http://www.airspayce.com/mikem/arduino/AccelStepper) that uses an encoder to record and correct motion.
☆10Updated 11 years ago
Alternatives and similar repositories for AccelStepperEncoder
Users that are interested in AccelStepperEncoder are comparing it to the libraries listed below
Sorting:
- Closed loop servo control for stepper motors☆10Updated 9 years ago
- Measures the elapsed time during each cycle of up to 8 input frequencies.☆35Updated 4 years ago
- ESP8266 Websocket<>Serial Bridge for LW3☆15Updated 7 years ago
- PCB design for a dual stepper drawing machine (i.e Eggbot/Spherebot/polargraph) controller based on Arduino Nano and Stepstick stepper dr…☆13Updated 9 years ago
- Arduino compatible reflow oven controller☆135Updated 12 years ago
- Inkscape GCode Exporter for K40 laser cutters running Marlin☆56Updated 9 years ago
- The Big Easy Driver available from SparkFun Electronics☆26Updated 6 years ago
- Marlin firmware modified and configured for LMN's buildlog.net inspired lasercutter☆52Updated 9 years ago
- 3D Engraving for the K40 laser cutter using Smoothieboard☆13Updated 9 years ago
- Part Libraries for CadSoft/Autodesk Eagle☆27Updated 4 years ago
- ☆43Updated 8 years ago
- Firmware for Replimat 3D printers, laser and plasma cutters, CNC mills, and other automation☆54Updated 7 months ago
- Talks I've given☆24Updated 5 years ago
- Custom Eagle parts that we've created where needed. Please feel free to use, extend, and share! (CC v3.0 Share-Alike You are welcome to u…☆42Updated last week
- Low Cost DIY Laser XY Scanner, Cutter, or Engraver☆41Updated 8 months ago
- Marlin-based Laser Cutter/Engraver firmware for RepRap Hardware ( Marlin 1.0.0 )☆29Updated 9 years ago
- NeoPixel Library that works with STM32duino. Tested with WS2812B.☆12Updated 9 years ago
- ViSi-Genie - Arduino Library☆57Updated 3 years ago
- Multiple High-Res Input & Output PPM Encoded Signal Streams on Teensy 4.x, 3.x & LC☆50Updated 3 years ago
- Inventables X-Carve specific Grbl versions:☆45Updated 6 years ago
- Simple GRBL support for Octoprint☆39Updated 7 years ago
- Neopixel Joints, millable on the Othermill☆27Updated 8 years ago
- Arduino controler for a closed-loop stepper motor☆88Updated 10 years ago
- An universal power block based on triac. In essence this is a solid state relay with some bells and whistles☆50Updated 5 years ago
- Measures the elapsed time during each cycle of an input frequency.☆74Updated 3 years ago
- SparkFun LED Driver Breakout -TLC5940☆12Updated 9 years ago
- Complete how-to for connecting and using I2C bus and SMBus between a Raspberry Pi and one or more Arduinos☆19Updated 4 years ago
- Open source I2C based datalogger. The bigger, better cousin to the original serial OpenLog.☆24Updated 2 years ago
- Arduino-compatible library to configure the Trinamic TMC2130 stepper motor driver☆42Updated 7 years ago
- servo-controlled reprap 3D printer☆98Updated 10 years ago