da-nie / FlirOneControlForLinuxLinks
Программа для работы с тепловизором Flir One для Linux на Qt5. Требуется libusb. Возможно, потребуется запуск от администратора через sudo (либо настройте права для libusb).
☆21Updated 5 years ago
Alternatives and similar repositories for FlirOneControlForLinux
Users that are interested in FlirOneControlForLinux are comparing it to the libraries listed below
Sorting:
- Arduino code to read Smart Battery data from laptop battery packs using SMBus/I2C☆115Updated 11 years ago
- Smart Battery System for ESP☆75Updated 7 years ago
- USB SMBus Interface☆163Updated 4 years ago
- SkyRC IMAX B6 / B6AC USB data reader☆32Updated 11 years ago
- Гербер файлы и BOM со схемой для STM32 Ethernet-RS485 шлюза☆22Updated 5 years ago
- New firmware for the FNIRSI-1013D osciloscope.☆152Updated 11 months ago
- USB/BLE to I2C/ADC Adapter☆35Updated 2 years ago
- ☆14Updated 11 months ago
- Hardware and software for interfacing Chrysler's legacy CCD/PCI/SCI-bus.☆76Updated last week
- Arduino-based portable GPS logger with LCD screen☆77Updated 6 years ago
- CAN bus sniffer on esp32-c3 + SN65HVD230☆31Updated 3 months ago
- ☆22Updated 2 years ago
- An alternative to expensive solution.☆20Updated 5 years ago
- Software, hardware and protocol information for the Eltek Flatpack2.☆55Updated 6 years ago
- Информация по сетевым интерфейсам на чипе esp32☆51Updated 7 months ago
- SMD hardware version of the Arduino IDE compatible 10MHz DiY Geiger counter☆17Updated 4 years ago
- Geiger counter☆58Updated 4 years ago
- cheap lipo charger☆32Updated last year
- An alternative firmware for the Riden WiFi module that provides Modbus TCP and SCPI support as well as a web interface.☆34Updated 4 months ago
- JDY-08 Bluetooth transparent transmission module, with resource for KiCAD☆65Updated 4 years ago
- Arduino based USB Linker protocol☆63Updated 6 years ago
- ESP32 dual mode bluetooth to serial port bridge☆55Updated last year
- attempt to restore buildability of Wildcat's DSO203 oscilloscope firmware + bugfixes☆29Updated 7 years ago
- A linux software to control ZTE Tech EBC A-series battery testers and electronic loads☆31Updated 2 years ago
- ☆39Updated last year
- Open source can bus analyzer software - with support for CANable / CANable2 / USB2CANFDV1, CANFD, and other new features☆21Updated last year
- BluePill/BlackMagicProbe support for CSR Programming☆20Updated 5 years ago
- v4l2 based solution to running Flir One from Linux☆107Updated 3 years ago
- 150W Electronic load / Battery discharge capacity tester PX-100 v2.70 protocol and control software. May be compatible with some DL24 ver…☆126Updated last year
- UCAN is an open source USB-to-CAN interface board, based on STM32F072 and candleLight open source firmware, and supports linux/win/mac mu…☆35Updated 2 years ago