bencorrado / pmsensorLinks
Library to read data from particulate matter sensors
☆21Updated 2 years ago
Alternatives and similar repositories for pmsensor
Users that are interested in pmsensor are comparing it to the libraries listed below
Sorting:
- Mes travaux sur les capteurs Xiaomi Mi Smarthome☆25Updated 8 years ago
- A MQTT to 433/315Mhz RF bridge build on the ESP8266 for home automation☆56Updated 6 years ago
- ESP8266 Smart Thremostat☆37Updated 8 years ago
- Easy MultiSensor device based on MicroPython☆62Updated 6 years ago
- ☆13Updated 8 years ago
- RFM69 gateway and controller for ESP8266☆45Updated 8 years ago
- Code for varios IoT devices☆64Updated 5 years ago
- ☆40Updated 8 years ago
- ESPHome support for cheap WiFi PIR sensors☆67Updated 3 years ago
- EZSP Firmware☆25Updated 3 years ago
- WeatherStation for the 2.9" ESPaper modules☆92Updated 3 years ago
- Some nodemcu based to run sonoff wifi enabled plugs through MQTT☆46Updated 5 years ago
- A BLE to MQTT bridge☆60Updated 6 years ago
- ☆24Updated 8 years ago
- ☆22Updated 5 years ago
- Xiaomi Zigbee to MQTT bridge using zigbee-shepherd☆99Updated 7 years ago
- Extremely low profile (13 mm height) 220 Volts switching relay, suitable to be inserted into the 220 Volts wall socket. Atmel ATMega328P…☆10Updated 6 years ago
- TI CC2652R w/ USB-UART in the ubiquitous "stick" form factor☆82Updated 4 years ago
- MY9291 LED driver library for Arduino ESP8266☆25Updated 7 years ago
- A sketch for the ESP8266 (or more directly NodeMCU) reading a temp from DS18B20 and pushing it to MQTT built using the Arduino IDE☆12Updated 8 years ago
- ESP8266-based smart wall switch☆133Updated 7 years ago
- Canny is a ESP8266 bridge replacement for Milight, Easybulb, Limitless and futlight clones using Muzzley☆27Updated 8 years ago
- Send data from dht and soil hygrometer by 433Mhz RF with a power consumption of 5uA☆22Updated 8 years ago
- Basic WeMos Shield with minimal features☆12Updated 8 years ago
- ZigBee CC2538 Coordinator for direct use on the GPIO of the Raspberry Pi☆23Updated 4 years ago
- ☆21Updated 3 years ago
- All about the MicroWakeupper Library (and BatteryShield for the Wemos D1 Mini)☆41Updated last year
- ESP8266 arduino project to read a CO2 value from a MH-Z19 sensor and post it on MQTT☆25Updated 4 years ago
- 433Mhz <-> MQTT gateway for smart home 🏡 automation☆40Updated 7 years ago
- esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA…☆56Updated 6 years ago