armageddon421 / electrodacus-esp32
☆20Updated 9 months ago
Alternatives and similar repositories for electrodacus-esp32:
Users that are interested in electrodacus-esp32 are comparing it to the libraries listed below
- The "missing manual" for the ElectroDacus Solar BMS (Solar Battery Management System) SBMS0☆24Updated 3 years ago
- Driver to embed the Chargery BMS to a Venus OS device☆32Updated last year
- Interface layer for Daly Smart BMS☆20Updated 3 years ago
- Just the Arduino Library for Overkill Solar BMSs☆34Updated 2 years ago
- This project is for connecting to EPEver charge controllers over WiFi for viewing running stats and also allows automatic posting of them…☆71Updated 7 months ago
- Read data from victron mppt and transport to mqtt server☆41Updated 2 years ago
- ☆62Updated 5 years ago
- Contains an Arduino project for Espressif ESP32 that will run a web server with web sockets to display data from a Victron MPPT charge co…☆26Updated 4 years ago
- Support files for managing and deploying my Victron Venus OS stuff☆19Updated 4 years ago
- A node red based dashboard for most EPEver/EPSolar solar charge controllers.☆68Updated last year
- ☆29Updated 2 years ago
- An arduino sketch to connect the EPSolar/EPEver Tracer A/B Series (RS-485 Modbus) to an ESP8266 and monitor using the Blynk mobile app.☆66Updated 5 years ago
- EPSolar Solar Charge Controller to MQTT☆43Updated 3 years ago
- JBD BMS and Thornwave bluetooth data monitoring☆44Updated 3 years ago
- Reads data from the Sage BMS console port and publishes to MQTT☆26Updated 3 weeks ago
- Converts the JK-BMS RS485 data to Pylontech CAN data☆76Updated 5 months ago
- ESP32 bridge allowing Daly Smart BMS to be used with a Sofar inverter/charger (and others that use SMA CANBUS protocol).☆32Updated last year
- An Arduino M0 based controller for Webasto C/E Diesel Water Heaters☆51Updated 2 months ago
- Arduino sketch for communicating with the ELV Max! system☆16Updated 10 years ago
- ☆42Updated 3 years ago
- Code for varios IoT devices☆62Updated 5 years ago
- Code to read the VE.Direct-Protocol from serial into a value array. Uses a non-blocking read loop and does checksum verification before a…☆126Updated 3 years ago
- Library for working with JBD BMS☆70Updated last year
- JBD BMS Linux utility☆60Updated 10 months ago
- Program to read out and display data from xiaoxiang Smart BMS over Bluetooth Low Energy☆101Updated 6 months ago
- Raspberry Pi 7" touchscreen for Venus OS (also HDMI)☆44Updated 2 months ago
- This is a RF signal encode and decode library that can be adapted to different protocols by specifying the timing conditions is a table. …☆35Updated last year
- EmonTx V3.4.x Hardware and older discreet firmware, see EmonTxV3CM repo for latest☆59Updated 8 months ago
- ESP8266 based WiFi interface for Voltronic Axpert MppSolar PIP inverters☆29Updated 3 years ago
- Use an ESP8266 to read live-, statistical- and status-data from an EpEver LandStar (LS1024B) via Modbus and publish using MQTT☆33Updated 6 years ago