arijav / AriloSprinkler-Firmware
OpenSprinkler Unified Firmware for OpenSprinkler, OpenSprinkler Pi, and OpenSprinkler Beagle.
☆15Updated 2 years ago
Alternatives and similar repositories for AriloSprinkler-Firmware:
Users that are interested in AriloSprinkler-Firmware are comparing it to the libraries listed below
- ☆10Updated 5 years ago
- ESP32 port of OpenSprinkler Unified Firmware☆24Updated 4 years ago
- 433MHz to MQTT Gateway using RFlink, Arduino Mega, and ESP8266☆46Updated 5 years ago
- Project to sync analog clocks to a few milliseconds.☆40Updated last year
- OpenSprinkler Unified Firmware for OpenSprinkler, OpenSprinkler Pi, and OpenSprinkler Beagle.☆9Updated 10 months ago
- ESP8266 and PZEM-004T based Power Meter☆25Updated 4 years ago
- ☆24Updated 8 years ago
- Device to measure energy and temperature☆80Updated 6 years ago
- ☆16Updated 6 years ago
- ☆11Updated last year
- Arduino Sketch for the DIY SmartBlinds project☆11Updated 4 years ago
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 2 years ago
- ESP8266/32 (HA Switch) ⯈ PCF8574 ⯈ 8-Relay☆51Updated 4 years ago
- Easy MultiSensor device based on ESP8266 using MySensors library☆22Updated 9 years ago
- ATtiny85 based LoRa atmospheric sensor board with BME280☆28Updated 6 years ago
- An all-in-one ESP8266 based weather station.☆19Updated 3 years ago
- Lora Soil Moisture Sensor☆55Updated 2 years ago
- RFM69 gateway and controller for ESP8266☆45Updated 8 years ago
- Send data from dht and soil hygrometer by 433Mhz RF with a power consumption of 5uA☆20Updated 8 years ago
- Full-featured Serial bridge for ESP8266, supports MQTT, WebSockets,Telnet, and also comes with a nice Config Page☆39Updated last year
- Terminal Shield for the WeMos D1 Mini with ESP8266☆20Updated 7 years ago
- Based on NodeMCU☆10Updated 9 years ago
- Small diy project to monitor the 12V car battery voltage of a vehicle in winter storage.☆27Updated 8 years ago
- Control Zemismart lights and the Sonoff B1 via E131 (xlights or vixen)☆26Updated 4 years ago
- A WiFi enabled PowerMeter for AC Voltage, Current and Power. Implementing a nice looking Web-Interface, a RESTful API, OpenHAB 1 & 2 Call…☆38Updated 5 years ago
- Outdoor Weather Station with Wind Speed, direction &Rainfall sensors☆57Updated 6 years ago
- Arduino/ESP8266 based sprinkler Controller☆31Updated 4 years ago
- RFID Wiegand MQTT Access☆27Updated 3 years ago
- Using ArduiTouch hardware as a smart home control center. This is currently a work in progress, but uploaded files are always tested and …☆20Updated 5 years ago
- ☆28Updated 3 years ago