architbubber / MultiWii-Nrf24l01-SingleBoardLinks
This is MultiWii code modified to work using Nrf24l01 as receiver on a single board . For QuadX the pins are remapped.
☆10Updated 4 years ago
Alternatives and similar repositories for MultiWii-Nrf24l01-SingleBoard
Users that are interested in MultiWii-Nrf24l01-SingleBoard are comparing it to the libraries listed below
Sorting:
- new document☆22Updated 7 years ago
- RC Reciever firmware using arduino and NRF24L01+☆88Updated 4 years ago
- The Next Step ...☆71Updated last week
- OpenAVRc Hardware and addons☆23Updated this week
- Arduino project to upgrade cheap Hobbyking HK-T6A or Flysky FS-CT6B transmitters or any other old RC TX☆62Updated 7 years ago
- OpenTX custom firmware for Transmitters☆54Updated 5 years ago
- Control just about anything RC☆65Updated 2 years ago
- This Arduino sketch expands the SBUS using an Arduino such as a small Ardiono Nano or ProMicro making the full 16 channels available on y…☆28Updated 4 years ago
- An Arduino 2.4GHz and IR remote controller with OLED display☆145Updated 4 years ago
- v202 2.4G arduino receiver☆63Updated 9 years ago
- ESP8266 based QuadCopter☆98Updated last year
- Arduino MSP (MultiWii Serial Protocol) library☆55Updated 7 years ago
- firmware for BoldClash BWHOOP B-03 quadcopter☆69Updated 5 years ago
- converts elrs CRSF serial signals into PWM pulses on output pins☆102Updated last year
- Arduino as SBUS to PWM decoder☆70Updated 2 years ago
- Make two ESP8266 wifi modules into a RC Transmitter and RC Reciever!☆12Updated 9 years ago
- ELRS receiver with an SX1280/1281 and 5 PWM outputs, based on the ESP8285.☆18Updated 3 years ago
- Generate a PPM Signal with an Arduino☆65Updated 2 years ago
- An atmel implementation of OpenSky FrSky-compatible RX☆13Updated 4 years ago
- Use Bayang transmitter to get PPM signal out☆12Updated 5 years ago
- WiFi Drone (ESP32)☆51Updated last month
- Custom DIY dual band (900/2400MHz) transmitter (handset) based on ExpressLRS.☆66Updated 2 years ago
- ESP32 ELRS handset☆53Updated 2 years ago
- STM32F411CEU6 Board Firmware☆216Updated last year
- Hobby RC 2.4GHz receiver based on cc2500 and STM32, supporting FrSky 2 Way D-series protocol☆28Updated 8 years ago
- ☆15Updated 5 years ago
- RC receiver. Includes nRF24L01+ transceiver, ATmega328P/PB processor, 2x motor controller with brake (e.g. tank-arcade mix) or servo outp…☆25Updated this week
- Arduino library for RC IBUS protocol - servo (receive) and sensors/telemetry (send) using hardware UART☆225Updated last year
- Arduino code to read iBus over serial port, and output PPM to FlightController. Future plans include PWM out for select channels.☆34Updated 5 years ago
- Arduino library that allows for emulation sensors for iBUStelemetry☆34Updated 7 years ago