alx / reprap-arduino-firmware
Arduino-based firmware for RepRap electonic
☆20Updated 16 years ago
Alternatives and similar repositories for reprap-arduino-firmware:
Users that are interested in reprap-arduino-firmware are comparing it to the libraries listed below
- Mechanical and electrical design files for revised version of my PCB Laser exposer☆16Updated 6 years ago
- 2D actuator☆28Updated 5 years ago
- GUI for grbl.☆51Updated 7 years ago
- Simplified design of an analog keypad matrix interface and demo thereof☆16Updated 3 years ago
- ESP8266 Websocket<>Serial Bridge for LW3☆15Updated 7 years ago
- A signal generator based on an ATtiny85 that generates a range of different waveforms☆31Updated 5 years ago
- A simple continuity tester, based on an ATtiny85 and a piezo buzzer.☆18Updated 7 years ago
- ☆17Updated 9 years ago
- stm8flash with support for the SPI-to-SWIM hack☆16Updated 6 years ago
- SAMD21G18A Sensor Board☆15Updated 8 years ago
- Firmware for Replimat 3D printers, laser and plasma cutters, CNC mills, and other automation☆52Updated 3 months ago
- XDisplace are a complete solution to mill, dispense solder paste and pixk and place components to a pcb in one process!☆12Updated 7 years ago
- Arduino library to control PT2314 AKA ET2314 audio processor☆13Updated 6 years ago
- A VERY cheap, tested, working, PIC based P.I.D. PID servo controller☆12Updated this week
- Solder Paste Dispenser☆18Updated 10 years ago
- Marlin-based Laser Cutter/Engraver firmware for RepRap Hardware ( Marlin 1.0.0 )☆29Updated 9 years ago
- Minimal I2C master routines for the new AVR microcontrollers.☆22Updated 3 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 4 years ago
- Speech library for Arduino☆39Updated 5 years ago
- 4 axis CNC, 3D, Laser Controller☆59Updated 5 months ago
- Javascript app to process a PCB image and output G-code suitable for laser engraver or similar machine. To reduce tool time, by default, …☆59Updated 2 years ago
- CNC machine control modules with Toslink optical cables☆27Updated 8 years ago
- 3D printable - DIY microscope☆14Updated 6 years ago
- ☆14Updated 4 years ago
- Arduino Support Package For Maple☆18Updated 9 years ago
- An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Ar…☆15Updated 9 years ago
- Servotor32 - Open-Source, Low-Cost USB 32 Servo Controller☆39Updated 8 years ago
- Raster to G-Code for LaserWeb☆19Updated 8 years ago
- Nano-Sized ATtiny85 devboard with USB Bootloader☆90Updated 8 years ago
- Branch of Grbl 0.9G provides planned spindle control for lasers☆10Updated 8 years ago