ali-raheem / eZ430-toolsLinks
Collection of scripts to interact with the eZ430 TI watch
☆61Updated 13 years ago
Alternatives and similar repositories for eZ430-tools
Users that are interested in eZ430-tools are comparing it to the libraries listed below
Sorting:
- OpenChronos - Open Source Firmware for the TI EZ430-Chronos Watch☆168Updated 10 years ago
- Scans LoRa channels displaying any monitored packets on the TFT display☆92Updated 8 years ago
- A Linux kernel SPI-driver for the RFM12B and RFM69CW RF modules by HopeRF☆114Updated 3 years ago
- rad1o: CCCamp15 SDR Badge☆106Updated 8 years ago
- nordic semiconductor wireless chipsets related code☆43Updated 11 years ago
- Fully modular opensource firmware for the eZ430 chronos using TI's new msp430-elf-gcc☆59Updated 6 years ago
- A lightweight wireless sensor library for Arduino☆83Updated 9 months ago
- ChipCon Tiny Loader, a 1KB serial bootloader for CC1110/CC1111☆63Updated 13 years ago
- IEEE 802.15.4 monitor based on TI CC2531 USB dongles☆75Updated 9 years ago
- A command-line tool to control 433MHz OOK based devices☆42Updated 6 years ago
- GUI frontend for rtl-sdr.☆91Updated 8 years ago
- Ook-decoder reads On-Off Keying radio data commonly used in the 433MHz ISM bands using a software defined radio (SDR).☆153Updated 4 years ago
- DroidScript for easier use of the BusPirate on your Android device.☆45Updated 8 years ago
- ESP8266 based Raspberry Pi WiFi module☆25Updated 9 years ago
- A low cost ISM radio to wifi gateway☆41Updated 5 years ago
- Software defined radio using Teensy 3.1, Teensy Audio shield and Softrock☆91Updated 8 years ago
- Automatically exported from code.google.com/p/rfexplorer☆22Updated 8 years ago
- Upconverter 125MHz v1.3 - Passive Upconverter Hardware Design for SDR☆80Updated 10 years ago
- OpenBench LogicSniffer repository☆326Updated 2 years ago
- ☆40Updated 10 years ago
- nRF24L01+ bootloader for avr and other mcus☆108Updated last year
- This repository contains resources to support the Guzunty Pi IO expansion board☆110Updated 8 years ago
- Automatically exported from code.google.com/p/dangerous-prototypes-open-hardware☆85Updated last year
- Simple spectrum analyzer☆132Updated 10 years ago
- The JTAGduino project has the goal of using Arduino as a JTAG interface.☆115Updated 11 years ago
- Setup and install for ARMinARM board.☆29Updated 9 years ago
- wxPython oscilloscope client for dangerousprototypes.com's Bus Pirate.☆47Updated 9 years ago
- A hackable open source sensor IoT board with network interface. A DIY Geiger counter KIT to contribute readings to the uRADMonitor networ…☆80Updated 2 years ago
- TI eZ430 Chronos modified firmware☆18Updated 11 years ago
- OLS is a $50 32 channel Logic Analyzer☆120Updated 14 years ago