akbooer / openLuup
a pure-Lua open-source emulation of the Vera Luup environment
☆41Updated 2 months ago
Alternatives and similar repositories for openLuup:
Users that are interested in openLuup are comparing it to the libraries listed below
- MQTT Gateway to unofficial Orbit B-Hyve API☆50Updated last month
- Enhancement Interface for VERA home automation system☆16Updated 3 years ago
- Python script for sending/receiving commands to/from GPIO pins via MQTT messages☆46Updated 5 years ago
- a Home-Automation-friendly ESP8266-based MQTT Garage Door Controller☆173Updated 6 years ago
- Connect Ubiquiti UniFi controller to MQTT☆73Updated 4 years ago
- ☆104Updated 5 months ago
- MQTT bridge for Philips Hue Dimmer and Hue Tap☆51Updated 7 years ago
- Use a NodeMCU and 2 MPU-6050's to monitor the status of your washer and dryer.☆18Updated 8 years ago
- Configuration for @brianjking Home Assistant☆84Updated 5 years ago
- ☆28Updated 6 years ago
- Digital version of my "analog" doorbell project to determine if the doorbell was pressed.☆59Updated 7 years ago
- Manage Wink Relay's native sensors and publish to MQTT☆46Updated 2 years ago
- A simple alarm control panel for Home Assistant's manual_mqtt alarm. Designed to run on a Raspberry Pi using an Adafruit 3.5" PiTFT.☆85Updated 4 years ago
- Home Automation Room Controller☆46Updated 9 years ago
- Generate Scenes for Home Assistant☆62Updated 5 years ago
- Node Red application for Home Automation integrating WInk API, SmartThings API, LIFX API. BlueIris API,IFTTT, INitialState, Forecast.io a…☆54Updated 7 years ago
- MQTT Support for RFLink Gateway (http://www.nemcon.nl/blog2) project☆36Updated last year
- ☆42Updated 7 years ago
- UNMAINTAINED - We are looking for someone to maintain ozwcp! The OpenZWave Control Panel (ozwcp for short) is an application built on the…☆130Updated 2 years ago
- Purisitic HA Dashboard theme.☆30Updated 6 years ago
- ☆80Updated 4 months ago
- A MQTT to 433/315Mhz RF bridge build on the ESP8266 for home automation☆56Updated 6 years ago
- A HDMI-CEC to MQTT bridge for connecting HDMI-CEC-devices to your Home Automation system.☆152Updated last year
- ☆55Updated 7 years ago
- Home Assistant configuration and Documentation for my Home. See ReadMe for device list.☆106Updated 3 years ago
- Python wrapper for OpenZWave's MQTT daemon☆49Updated 3 years ago
- MySensors plugin for the Vera controller☆29Updated 2 years ago
- Alternative firmware for Arilux AL-LC0X LED controllers, based on the MQTT protocol and a TLS connection☆190Updated 5 years ago
- ibbq Inkbird ble to mqtt bridge ESP32 based☆37Updated 4 years ago
- A water detector to prevent flooding that runs on LiPO batteries and transmits its status and notifications via MQTT☆69Updated 6 years ago