TRD-B / LizardLinks
3D printed RC race car with custom electronics
☆103Updated 5 months ago
Alternatives and similar repositories for Lizard
Users that are interested in Lizard are comparing it to the libraries listed below
Sorting:
- 3D printer control board based on ESP32,support 8 Driver motors.☆87Updated 4 months ago
- ☆47Updated last year
- List of controllers supported by grblHAL☆60Updated 3 weeks ago
- A low cost stepper motor analyzer that uses wireless BLE link to display the data in real time on a Windows/Mac/Linux PC.☆55Updated 2 years ago
- STM32H7 based Robust and Open Source 3D Printer Mainboard☆71Updated 3 months ago
- CAN bus extruder, more resistant to noise,reduce a lot of wires for your 3D printer☆116Updated 2 years ago
- FYSETC Board - The E4 board is a minimal 3D printer control board based on the ESP32 microcontroller from ESPRESSIF, with built-in Wi-Fi …☆73Updated 9 months ago
- Alternative to PanelDue. Embedded UI for Duet & RepRap based 3D printers. Running on the ESP32. Optimized for 3.5" displays. WiFi or UART…☆89Updated 3 years ago
- A DYI stepper motor analyzer. This is a new design that is based on Raspberry Pi Pico and users a compact single PCB design. NOTE: The l…☆155Updated 2 years ago
- A Multidirectional 5-Axis FDM Slicer☆142Updated 5 months ago
- Need to transport a pencil across your desk or perhaps a stack of sticky notes? Never fear the MiniDump is here.☆19Updated 2 years ago
- ESP32 DIY Digital Readout☆109Updated 6 years ago
- MKS SERVO42C, an upgraded version of MKS SERVO42B, built-in Field-Oriented control algorithm, position/speed/ torque closed-loop, 4 Half…☆211Updated 2 years ago
- MKS TinyBee is a mainboard for 3d printing, based on ESP32 module☆164Updated 3 years ago
- CAD & Electronics for Powercore V1☆161Updated 2 years ago
- Kiln PID controller based on Espressif Systems ESP32 chip board with Arduino IDE.☆158Updated last year
- ESP3D Firmware for ESP32 based TFT☆48Updated last month
- Raspberry Pi Pico based grblHAL Controller☆161Updated last month
- Klipper_ESP32 is an implementation of the Klipper protocol for Espressif's ESP32 microcontroller set.☆74Updated 4 months ago
- An Arduino shield to test the TMC2209 stepper motion controller by Trinamic.☆37Updated 2 years ago
- A basic 3D printer control board based on ESP32☆58Updated 6 years ago
- A Multidirectional 5-Axis 3D Printer☆198Updated 5 months ago
- DIY Printed small PCB CNC for fast Prototyping☆57Updated 4 years ago
- A CNC Pendant on ESP32 board, with LCD, WiFi and SD card☆81Updated 5 months ago
- A powerful 32-bit 3D printer control board.☆74Updated 5 years ago
- A Pendant for FluidNC CNC Firmware☆78Updated 2 weeks ago
- ☆35Updated 2 years ago
- The MUB - An ultra-compact, modular processing unit☆63Updated 3 years ago
- ☆60Updated 2 years ago
- Pendants for controlling FluidNC CNC firmware☆44Updated 9 months ago