Schack17 / PaulFocusNovusLinks
☆11Updated 3 years ago
Alternatives and similar repositories for PaulFocusNovus
Users that are interested in PaulFocusNovus are comparing it to the libraries listed below
Sorting:
- Communicate with Viessmann boilers using the optolink for ESP8266 and ESP32☆130Updated 2 months ago
- Victron Venus Os Plugin for Plenticore Plus inverters☆23Updated this week
- Arduino-based controller for Daikin Altherma heat pumps. The controller connect to the Altherma heat pump via P1/P2 bus, has a built-in w…☆57Updated 2 weeks ago
- A service for Venus OS, reading smart meter data from a Fronius system and making the values available on dbus.☆22Updated last year
- Fhem module for snips.ai☆13Updated 6 years ago
- Open-source firmware for STM32 co-processor on the Shelly Dimmer.☆55Updated last year
- Control Hörmann doors directly via MQTT☆119Updated 7 months ago
- Node-RED Nodes for ZigBee Devices 🐝☆85Updated 2 years ago
- Alternative culfw☆128Updated 2 years ago
- ☆20Updated 2 months ago
- ☆38Updated 2 years ago
- vcontrold Daemon for control and logging of Viessmann® type heating devices☆114Updated 11 months ago
- a software for a raspberry pi zero to read the production of aps inverters yc600 and qs1☆51Updated last week
- This is the library of the KNX-User-Forum Arduino project initiated by thorsten Gehrig☆55Updated 2 months ago
- ☆107Updated last year
- Receives messages from an enOcean serial interface (USB) and provides selected messages to an MQTT broker.☆45Updated 6 months ago
- ESPHome support for cheap WiFi PIR sensors☆67Updated 4 years ago
- Freeing the Silvercrest (Lidl/Tuya) Smart Home Gateway from the cloud.☆34Updated 4 years ago
- Itead Studio SonoffSC custom firmware with MQTT and Domoticz support☆104Updated 6 years ago
- emulates Hoermann HAP 1 HCP (HCP2) on ESP8622, ESP32 and Arduino.☆96Updated 4 years ago
- Victron VenusOS dbus binding for Kostal Plenticore inverters☆11Updated 3 years ago
- ESPHome component to monitor and control a EVSE wallbox☆12Updated 3 weeks ago
- Firmware for ESP8266 allowing eBUS communication for ebusd (https://github.com/john30/ebusd)☆156Updated last year
- Homie based bridge between MQTT and RFlink module☆22Updated 5 years ago
- Readout of EMS protocol datagrams and transfer of data to Domoticz via Arduino☆90Updated 4 years ago
- ESPHome Component for Daikin Mini-Splits using the S21 serial port.☆91Updated last month
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- Modbus RTU to MQTT Gateway☆90Updated last month
- This nodes for Node-RED allow to control devices which are connected to the Home Connect system.☆19Updated last year
- ☆40Updated 5 months ago