Salandora / octoprint-customControlLinks
This plugin makes Custom Controls editable through the OctoPrint WebUI
☆26Updated 5 years ago
Alternatives and similar repositories for octoprint-customControl
Users that are interested in octoprint-customControl are comparing it to the libraries listed below
Sorting:
- Plugin for OctoPrint - saves filename, print time and filament usage for each print☆64Updated 9 months ago
- Plugin for OctoPrint - displays temperatures on navbar☆45Updated 9 months ago
- Slic3r plugin for slicing within OctoPrint☆91Updated 2 years ago
- Edit gcode on OctoPrint☆22Updated 2 years ago
- ☆44Updated 2 years ago
- A hardware remote for Octoprint controlled 3D Printers☆21Updated 6 years ago
- Simple FileManager for OctoPrint☆26Updated 4 years ago
- A full-blown GUI-based slicer plugin for OctoPrint☆101Updated 8 months ago
- Plugin for automatically shutting down the system after print is finished☆18Updated 3 years ago
- Bondtech extruder upgrade for Prusa i3 printer.☆159Updated 4 months ago
- ☆37Updated 3 years ago
- A OctoPrint touch interface for TFT touch modules based on GTK+3☆174Updated 5 years ago
- Automatically heat printhead to the printing temperature of the current gcode file☆37Updated 4 years ago
- ☆23Updated last week
- An OctoPrint plugin to view current CPU and RAM usage☆41Updated last year
- ☆63Updated 5 years ago
- A plugin for a better integration of Klipper into OctoPrint.☆85Updated 4 years ago
- Arduino/Marlin firmware flasher for OctoPrint☆39Updated last year
- ☆24Updated 4 years ago
- A touchscreen client for Octoprint☆26Updated 8 years ago
- OctoPrint-Plugin☆121Updated 2 years ago
- This plugin was created to calibrate 3D printer settings easily.☆36Updated 2 years ago
- ☆33Updated 8 years ago
- Interactive temperature graph for octoprint☆19Updated 4 years ago
- Scripts to build OctoPi, a Raspberry PI distro for controlling 3D printers over the web☆54Updated 5 years ago
- Pause print on GPIO sensor☆25Updated 7 years ago
- Smart control of your power supply via GPIO, GCODE Command, System Command, or variety of sub-plugins.☆211Updated last year
- Use a gcode pre-analysis to provide better print time estimation☆208Updated 4 months ago
- Marlin3dPrinterTool is a open-source software that helps you configure and test your 3D printer.☆259Updated 2 years ago
- Plugin for Cura to make debugging settings problems much easier.☆12Updated 3 years ago