SUPLA / supla-coreLinks
Core server and system components of the SUPLA smart home platform.
☆78Updated last week
Alternatives and similar repositories for supla-core
Users that are interested in supla-core are comparing it to the libraries listed below
Sorting:
- ☆65Updated 7 years ago
- ☆33Updated 11 months ago
- ESP8266-based smart wall switch☆132Updated 7 years ago
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 3 years ago
- ESP8266 WIFI serial to emoncms link☆169Updated 2 years ago
- ESP8266 WiFi Smart Thermostat based on Souliss IoT Framework☆108Updated 7 years ago
- Plugin for a rapid development of battery-powered sensors☆135Updated 3 years ago
- Universal I/O bridge for the ESP8266, including GPIO, I2C and UART (serial bridge)☆139Updated last year
- An arduino library to communicate using the Dallas one-wire protocol, where the Arduino takes the role of a slave. Entirely implemented u…☆58Updated 7 years ago
- NodeMCU ESP8266 RF Gateway and Display Board☆117Updated 7 years ago
- MY9291 LED driver library for Arduino ESP8266☆25Updated 8 years ago
- Connects sensors/actuators to MQTT broker. Simpler than MQTT-SN. Runs on nRF24L01 hardware.☆64Updated 11 years ago
- ESP8266 displaying mqtt messages on a Nokia 5110 LCD☆70Updated 9 years ago
- ❌This repo is not maintained anymore❌☆21Updated 9 years ago
- Three Channel WiFi Relay/Thermostat Board☆146Updated last year
- RFM69 gateway and controller for ESP8266☆44Updated 9 years ago
- Local Sensors☆78Updated 8 years ago
- Full-featured Serial bridge for ESP8266, supports MQTT, WebSockets,Telnet, and also comes with a nice Config Page☆40Updated 2 years ago
- Some nodemcu based to run sonoff wifi enabled plugs through MQTT☆46Updated 6 years ago
- Web framework for ESP8266☆144Updated 8 years ago
- ESPiLight - pilight 433.92 MHz protocols library for Arduino☆124Updated 2 years ago
- Chinse Wifi rgbww controller module hack☆52Updated 9 years ago
- OpenBeacon.org Active 2.4 GHz RFID tracking for nRF51822☆12Updated 10 years ago
- Melvanimate☆60Updated 8 years ago
- Swifitch is ESP8266 based relay board that could be used to turn any light or any wall socket into smart one!☆134Updated 7 years ago
- ☆32Updated 7 years ago
- 433mhz rf sniffer and receiver☆121Updated 4 years ago
- Open firmware for Honeywell Rondostat HR20 and similar thermostats☆90Updated 5 years ago
- ☆63Updated 2 years ago
- Arduino Software for RS485 support with collision detection and message handling capabilities☆113Updated 7 years ago