Rhizomatica / hermes-netLinks
Network subsystems of the HERMES telecommunication system
☆21Updated 3 months ago
Alternatives and similar repositories for hermes-net
Users that are interested in hermes-net are comparing it to the libraries listed below
Sorting:
- This project is a set of AX.25 microservices, to be pluggable for any implementation.☆33Updated 3 months ago
- Tools to integrate HF TNCs to UUCP☆14Updated 3 years ago
- A rewrite of Dr. Tony Fisher's software modem for Linux.☆38Updated 5 years ago
- TNC for Raspberry Pi Pico☆72Updated 3 months ago
- Source for various version of ARDOP☆13Updated last year
- DCF77 time signal GNURadio receiver for SDRs incl. live decoder and transmitter simulation. It covers both OOK and phase modulation.☆26Updated 2 years ago
- Schematics of the SMART Response XE terminal☆51Updated 3 years ago
- V.23 Softmodem for Asterisk with some Bildschirmtext-specific stuff in it.☆68Updated 7 years ago
- Radio Autoencoder - transmission of vocoder features over radio channels☆49Updated last week
- A custom, naive RIPv2 daemon for Amprnet tunnel route maintenance☆19Updated 3 years ago
- An adjustable T Match where the capacitors and inductors are on the PCB.☆16Updated 2 years ago
- Mercury is a configurable open-source software-defined modem.☆104Updated 2 months ago
- Mainboard replacement for Nokia 3310☆58Updated 4 months ago
- A simple v.23 modem including the data link layer. This is an application for Asterisk☆17Updated 9 months ago
- TR-9 - M17 protocol compatible handheld - schematics, PCB design files, BOM.☆170Updated 3 years ago
- Simple OFDM modem for transceiving datagrams☆124Updated 3 months ago
- An attempt to re-create a KISS TNC algorithm in LoRa using Arduino☆14Updated 7 years ago
- WIP: Port of Reticulum Network Stack to C++ specifically but not exclusively targeting ESP32 and better MCUs.☆26Updated 7 months ago
- Arabell300 is an Arduino-based 300 baud modem implementing Bell 103 and ITU V.21 standards. Features Hayes-compatible AT commands, AFSK…☆25Updated 3 months ago
- A modem/TNC to generate the AFSK audio tones for sending APRS messages using a Raspberry Pi Pico/Pico2☆45Updated 3 months ago
- ☆31Updated last year
- ☆12Updated 5 years ago
- A SDR PCB project base on msi2500 and msi001☆61Updated 3 years ago
- KISS TNC using FreeDV Modem☆36Updated last year
- A FreeDV device based on the ESP32.☆105Updated last year
- Digital controlled radio frequency oscillator based on Raspberry Pi Pico (1 Hz to ~32.333 MHz band). RTTY, MFSK, freq sweep examples are …☆70Updated last year
- Mobilinkd TNC1 Firmware☆52Updated 7 years ago
- Arduino library with LCD, Keyboard and SPI Flash support for the SMART Response XE classroom communicator☆101Updated 2 years ago
- Universal POCSAG transmitter controller written in Rust.☆101Updated last year
- Using an old 8-bit ISA VGA card with Arduino Mega☆21Updated 11 months ago