PetteriAimonen / QuadPawn
Pawn scripting language for the DSO Quad pocket oscilloscope.
☆76Updated 3 years ago
Alternatives and similar repositories for QuadPawn:
Users that are interested in QuadPawn are comparing it to the libraries listed below
- SourceCode for DSO Quad HWv2.6☆74Updated 3 months ago
- FX2 EZ USB eeprom reader/writer for libusb☆29Updated last year
- Firmware for the D6 Simple spectrum analyzer with tracking source (T.G.)☆23Updated 4 years ago
- ☆59Updated 11 years ago
- STM32F030F4P6 breakout board pcb files and example code☆14Updated 9 years ago
- Hardware of Jasper's Electronic Load R2☆21Updated 6 years ago
- Little Wire is multi-featured USB controlled open source hardware tool packed in a minimal form factor designed by ihsan Kehribar.☆100Updated 7 years ago
- USB 10 digit seven segment display unit☆14Updated 5 years ago
- ☆24Updated 6 years ago
- Open Source Reflow Oven Controller.☆19Updated 2 years ago
- attempt to restore buildability of Wildcat's DSO203 oscilloscope firmware + bugfixes☆27Updated 6 years ago
- Display Parallel Interface HAT (Hardware Attached on Top) for Raspberry Pi☆18Updated 4 years ago
- Curve tracer - hardware source files☆23Updated 7 years ago
- ☆39Updated 9 years ago
- Repository for OSHW Reflow Oven Control☆26Updated 10 years ago
- QN8027 Single-Chip FM RDS Transmitter Arduino Library☆22Updated 5 years ago
- Arduino software for an electronically controlled load, based on a STM32 microcontroller☆21Updated 4 years ago
- A touch controlled light with 4xWS2812 RGB LEDs and ATtiny 10☆34Updated 5 years ago
- SAMD21G18A Sensor Board☆15Updated 8 years ago
- ESTechnical Reflow Oven Controller source code and instructions☆47Updated 9 years ago
- ☆19Updated 6 years ago
- This is all of the code, datasheets and design files for my instructable☆37Updated 8 years ago
- AVR micro USB key☆29Updated 12 years ago
- Andy's Workshop Reflow Oven Controller☆33Updated 7 years ago
- Library for interfacing the Arduino with TEA5767 single chip FM radio☆63Updated 12 years ago
- Inlined STM8S SPL (STM8S103) for use with SDCC☆11Updated 6 years ago
- ☆23Updated 9 years ago
- Android-based multitouch interface for Rigol oscilloscopes☆27Updated 5 years ago
- Set the voltage of a Quick Charge 2.0 source via the Arduino.☆67Updated 7 years ago