MrBreadWater / project-kronos-data-collectorLinks
Simple Octoprint Plugin to collect a Neural Network dataset of 3D Print timelapses.
☆15Updated 5 years ago
Alternatives and similar repositories for project-kronos-data-collector
Users that are interested in project-kronos-data-collector are comparing it to the libraries listed below
Sorting:
- Adds a parts fan speed slider to octoprint's UI☆22Updated 5 years ago
- WiFi Controlled Desk Lamp☆62Updated 5 years ago
- An OctoPrint Plugin that adds support for MQTT.☆163Updated last year
- Adds RGB LED support to OctoPrint with the ability to choose effects based on the current status of your printer☆34Updated 4 years ago
- What could be better than using OctoPrint or WLED? A plugin to use both!☆62Updated last year
- ☆20Updated last year
- ☆48Updated 2 years ago
- Smart control of your power supply via GPIO, GCODE Command, System Command, or variety of sub-plugins.☆213Updated 2 years ago
- Add some RGB LEDs to your printer for a quick status update!☆118Updated last year
- Extends the Control tab of OctoPrint, allowing the ability to switch between multiple webcam feeds.☆52Updated 11 months ago
- Resin.io / Docker setup for OctoPrint on Raspberry Pi 3B/3B+☆19Updated 5 years ago
- ESPHome configuration for energy 6 channel CT clamp board. Used for energy monitoring 6 circuits.☆19Updated 3 years ago
- Overseer is a utility that allows for monitoring multiple 3d printers.☆28Updated 2 months ago
- ☆141Updated last month
- ☆37Updated 3 years ago
- Perform actions, send gcode or system commands on OctoPrint with buttons connected to gpio pins☆34Updated last year
- ESP8266 and OLED Pi-hole Monitor☆87Updated 2 years ago
- Pause print on GPIO sensor☆25Updated 7 years ago
- Plugin for slicing via Cura Legacy from within OctoPrint☆20Updated 4 years ago
- ☆66Updated 4 months ago
- OctoPrint / Octopi plugin to control relays☆50Updated last week
- OctoPrint plugin that intercepts M150 GCode commands and controls local GPIOs connected to LEDs.☆65Updated 5 years ago
- A touch friendly interface for a small TFT module or phone☆275Updated last year
- ☆44Updated 2 years ago
- Firmware for Original Prusa i3 3D printer by PrusaResearch☆12Updated 7 years ago
- ☆22Updated 8 months ago
- OctoPrint plugin to manage your filament inventory☆59Updated 2 years ago
- A OctoPrint touch interface for TFT touch modules based on GTK+3☆70Updated 5 years ago
- Create amazing timelapse videos with your DuetWifi-based printer☆41Updated 5 years ago
- A OctoPrint touch interface for TFT touch modules based on GTK+3☆174Updated 6 years ago