MCUdude / optiboot_flashLinks
Optiboot subtree for MightyCore, MegaCore, MiniCore and MajorCore
☆59Updated 2 years ago
Alternatives and similar repositories for optiboot_flash
Users that are interested in optiboot_flash are comparing it to the libraries listed below
Sorting:
- Measures the elapsed time during each cycle of an input frequency.☆74Updated 3 years ago
- Modified BootLoader to load firmware from sd or flash☆45Updated last year
- Want to use all SIX GPIO pins on the ATTiny85? Now you can.☆17Updated 6 years ago
- Arduino compatible reflow oven controller☆136Updated 12 years ago
- GUI for pcb2gcode☆134Updated 2 months ago
- A standalone programmer for mass-programming AVR chips☆86Updated 4 years ago
- Set the voltage of a Quick Charge 2.0 source via the Arduino.☆68Updated 8 years ago
- Alternative firmware for the B3603☆67Updated 7 years ago
- An all-in-one Arduino compatible reflow controller powered by ATtiny1634R☆128Updated 4 years ago
- Measures the elapsed time during each cycle of up to 8 input frequencies.☆35Updated 4 years ago
- ATtiny85/45/25 I2C bootloader☆113Updated 2 years ago
- Arduino library for data transmission using common 315Mhz and 433Mhz transmitters using Manchester encoding. Good for using with microcon…☆28Updated 9 years ago
- An improved ATMega328P with this cheap clone Logic Green LGT8F328P☆154Updated 3 years ago
- Telnet to Serial bridge for LaserGRBL☆53Updated 7 years ago
- Arduino sketch for burning new bootloaders☆203Updated 3 years ago
- An alternative library to Arduino's Wire library☆50Updated 10 years ago
- SparkFun's Arduino Pro Mini 328 is a bare bones super small Arduino compatible development board.☆103Updated 6 years ago
- ATTiny Core for Arduino 1.0+☆87Updated 8 years ago
- Reflow Oven Controller. See below for more information.☆79Updated 6 years ago
- ESP8266-based I2S-output WS2812(B) Driver☆51Updated 9 years ago
- DIY Electronic load for DCDC converter characterization☆51Updated 5 years ago
- Use the Arduino to program AVR chips.☆128Updated 13 years ago
- Schematics and code for the Re:load Pro☆102Updated 8 years ago
- OSC Calibrator and High-Voltage Fuse Resetter for 8-Pin ATtinys☆58Updated 2 years ago
- Modification of USBasp firmware to support UART debugging.☆63Updated 5 years ago
- Arduino STM32. Hardware files to support STM32 boards, on Arduino IDE 1.8.x including LeafLabs Maple and other generic STM32F103 and STM3…☆41Updated 7 months ago
- A CNC controller to use and test Grbl_ESP32☆79Updated 5 years ago
- An Arduino hardware package for ATmega8515 and ATmega162☆43Updated 11 months ago
- 🏗️ An I2C bootloader for Arduino.☆69Updated 3 years ago
- USBasp for ATtiny85☆33Updated 3 years ago