Lennart-O / TCCharger-voltage-current-controlLinks
TCCharger voltage & current control
☆14Updated 7 years ago
Alternatives and similar repositories for TCCharger-voltage-current-control
Users that are interested in TCCharger-voltage-current-control are comparing it to the libraries listed below
Sorting:
- The source code for the CAN controller for TC chargers can be found here, as well as the correct library for the MCP chip which works str…☆12Updated 6 years ago
- ESP32 based CAN development board☆183Updated 3 years ago
- Arduino library for communicating with Daly BMSs over UART☆113Updated 2 years ago
- Arduino IDE support files for CAN enabled Atmel AVR chips: ATmega64M1, ATmega32M1, ...☆30Updated 4 years ago
- Software for diyBMS v4☆152Updated last year
- Do it yourself battery management system for Lithium ion battery packs/cells☆152Updated 7 years ago
- ☆14Updated 9 years ago
- Isolated current, voltage and SOC monitor for battery banks up to 85V☆54Updated 2 years ago
- Arduino ODBII ELM327 Emulator - Allows Arduino to act as an OBD2 ELM327 device and responde to PID requests☆68Updated 2 years ago
- J1772 Hydra for Arduino☆16Updated 6 years ago
- Open Inverter - Alternative Web Interface☆34Updated 4 years ago
- Example code to communicate with Huawei R4850G2 Power Supply via CAN☆77Updated last year
- Variable Frequency Drive for ATmega328 based Arduinos☆86Updated 7 years ago
- This is an Arduino library providing an emulation of the CAN communication protocol of the BMS (battery management system) on a Renault T…☆92Updated 2 years ago
- RD6006 Python module☆106Updated last year
- Megasquirt Gauge using CAN bus.☆35Updated 3 years ago
- ☆205Updated 9 months ago
- An Arduino based LINBUS stack and signal interceptor/injector.☆201Updated 6 years ago
- Arduino library for CAN on Teensy 3.1, 3.2, 3.5 and 3.6☆78Updated 7 years ago
- An ATTiny version of Julian Iletts PWM5 Solar Charge Controller☆50Updated 4 years ago
- Grbl Mega optimized for plasma cutting☆13Updated 3 years ago
- CAN_Interface for ESP32 (Cannelloni Protocol)☆59Updated 4 years ago
- An opensource solution for connecting OBD2 straight to the Nissan Leaf battery☆66Updated last year
- An Arduino sketch for controlling a Bosch LSU 4.9 Wideband Lambda sensor with minimal parts☆85Updated 12 years ago
- Library for working with JBD BMS☆76Updated last year
- LIN master node emulation with preemptive background operation☆33Updated last year
- diyBMS v4 code for the ESP32 and new controller hardware☆222Updated 2 months ago
- 150W Electronic load / Battery discharge capacity tester PX-100 v2.70 protocol and control software. May be compatible with some DL24 ver…☆126Updated last year
- The Valden Heat Pump controller is a platform to precisely control heat pumps☆151Updated 4 years ago
- A python library for Riden RD power supplies☆67Updated last year