JDet-74 / C128toSCART_THTLinks
A project to connect a Commodoer C128 or another CGA Device to a SCART device
☆12Updated 4 years ago
Alternatives and similar repositories for C128toSCART_THT
Users that are interested in C128toSCART_THT are comparing it to the libraries listed below
Sorting:
- ROM bank switching cartridge for the Commodore 128☆13Updated 2 years ago
- ☆18Updated last year
- A project to clone the FDC controller Cart for C64☆13Updated 3 years ago
- Software controlled ID switch for Commodore disk drives.☆14Updated 2 years ago
- A new design of the megabit adapter for U36 in the C128☆15Updated 3 years ago
- Use bigger EPROMs to replace smaller ones with switchable images☆17Updated 7 years ago
- CBM 1551 paddle replacement / mass storage using an SD card interfacing with the Commodore C16/116/Plus4 simulating a TCBM bus 1551 disk …☆13Updated last month
- 65(c)02 to 7501/8501 converter☆18Updated 3 years ago
- ☆14Updated last year
- An 8 4164 to 2 4464 conversion PCB for various Commodore 64 motherboards☆13Updated 5 years ago
- Sounds from C64 now for Plus/4!☆15Updated 6 months ago
- A further in SMT developed Version of the C128toSCART_THT project☆15Updated 3 years ago
- This is a tester for Commodore matrix keyboards☆24Updated last year
- Commodore 64 PLA replacement☆30Updated 7 years ago
- Replica of the Commodore C128 Diagnostic Test cartridge Assy No. 325093-01.☆16Updated 8 months ago
- Changes the orientation of a 68000 DIP CPU☆15Updated 6 years ago
- This is a software for analyzing the Commodore C64 SID. Every parameter for every voice can be set separately. The base address of the SI…☆15Updated 6 years ago
- Commodore VIC-20 Dead Test☆16Updated 5 months ago
- Commodore 1541 Floppydrive Multi-Speeder Project☆16Updated 9 months ago
- An Adaptor for the Character ROM of the Commodore C64☆19Updated 3 years ago
- An internal WiFi using ESP32 microcontroller for Commodore computers (C64, C128) with level translators to a parallel bus interface so it…☆14Updated 5 years ago
- It's a tapuino, mostly because I wanted to build one. Uses an Arduino to load tapes on the good old Commodore 64.☆18Updated 3 years ago
- A flexible trapdoor extension for the AMIGA 500☆14Updated 4 years ago
- Commodore 1530 Datassette Connector Breakout PCB☆12Updated 7 years ago
- C64 Pi Interface☆14Updated 2 weeks ago
- This is a Kernal Adapter/Switch for the Commodore C64 long board☆17Updated 3 years ago
- Library to connect Arduino to the Commodore IEC bus☆27Updated this week
- ☆12Updated 4 years ago
- PCMCIA SRAM card project (Sakura) - rev 2.1.2019☆11Updated 6 years ago
- Hardware design of Magic Desk compatible C64 cartridge up to 1024k☆19Updated 10 months ago