Guizz27 / DWIN_LK4Pro
LKx Pro touchscreen firmware. Should work with Alfawise U30 Pro and Longer LK5 Pro
☆16Updated last year
Alternatives and similar repositories for DWIN_LK4Pro:
Users that are interested in DWIN_LK4Pro are comparing it to the libraries listed below
- Marlin 2.0/2.1 for Longer LKx Pro. Should also work with Alfawise U30 Pro☆37Updated last year
- Optimized firmware for RepRap 3D printers based on the Arduino platform. Modified with a new DGUS touchscreen implementation.☆16Updated last year
- MKS H43 is a 4.3-inch high-definition IPS display with a resolution of 800*480 and uses a capacitive touch screen. This is a high-end scr…☆33Updated 2 years ago
- This library contains all the open source materials of BIGTREETECH touch screen hardware.☆170Updated 7 months ago
- Optimized firmware for RepRap 3D printers based on the Arduino platform. Modified with a new DWIN T5UID1 touchscreen implementation.☆16Updated last year
- ☆92Updated 10 months ago
- Marlin Firmware configured for FLSUN Super Racer with MKS Robin Nano V3 motherboard.☆69Updated 2 years ago
- ☆89Updated last month
- DWIN T5UID1 touchscreen firmware for 3D printers running Klipper.☆171Updated 2 years ago
- DWIN T5UID1 touchscreen firmware for 3D printers running Marlin.☆74Updated 3 years ago
- ☆282Updated last year
- ☆25Updated 10 months ago
- ☆235Updated 2 months ago
- Printed version of the Vz-Printhead☆131Updated 2 weeks ago
- BIGTREETECH Relay V1.2 is an upgrade of the original (BIGTREETECH V1.0). After upgrading, a small MCU was added on the module to make the…☆128Updated 3 years ago
- Klipper is a 3d-printer firmware☆145Updated this week
- The official repo for the BTT Pi2 and CB2☆77Updated 7 months ago
- Klipper NeoPixel Templates☆191Updated 2 years ago
- Installing klipper on orange pi zero 2☆26Updated 11 months ago
- ☆212Updated 5 months ago
- Armbian Linux Build Framework☆103Updated 3 weeks ago
- ☆56Updated 8 months ago
- This is OCTOPUS Pro open source material☆289Updated last year
- SR/V400 Klipper (Follows spec and, OFFICIAL Klipper docs or OFFICIAL devices setup instructions)☆34Updated 10 months ago
- ☆196Updated 3 years ago
- ☆149Updated 2 years ago
- Klipper Installation And Update Helper☆55Updated last year
- Firmware for Original Prusa i3 3D printer adapted by CM3D☆19Updated last year
- Stripped down version of BIGTREETECH-TouchScreenFirmware which only supports ST7920 emulation (Marlin Mode)☆155Updated 2 years ago
- ☆68Updated last year