Espablo / SUPLA_Firmware
☆22Updated 4 years ago
Alternatives and similar repositories for SUPLA_Firmware:
Users that are interested in SUPLA_Firmware are comparing it to the libraries listed below
- ☆19Updated this week
- ☆9Updated last year
- Device to measure energy and temperature☆80Updated 5 years ago
- ESPHome support for cheap WiFi PIR sensors☆66Updated 3 years ago
- esp8266 IoT to mqtt bridge. Eastron SDM220, SDM230, SDM630 modbus; AZ7798; SenseAir s8; BME280; HDC1080; Plantower PMS5003, PMS7003, PMSA…☆20Updated 2 years ago
- Home Assistant / Domoticz tested with a RFLink, modified for ESP8266 and ESP32☆108Updated 3 years ago
- RFLink for ESP, with MQTT client☆72Updated last year
- Cheap power monitor (STC013) with Home Assistant Discover and Wemos D1 Mini / PRO (esp8266)☆114Updated 3 years ago
- Read data from victron mppt and transport to mqtt server☆41Updated 2 years ago
- MQTT WiFi ESP8266 Single Channel Relay☆10Updated 4 years ago
- RFLink modified for ESP8266 and ESP32 ---> RF 433mhz to MQTT gateway☆26Updated 3 years ago
- Arduino library for read weather data from Venus W174/W132 (tested), Auriol H13726, Hama EWS 1500, Meteoscan W155/W160☆25Updated last year
- MQTT 433.92 MHz radio-frequency device gateway☆137Updated 2 years ago
- ☆24Updated 8 years ago
- A ESP8266 based DSMR reader, posting onto MQTT☆36Updated 2 years ago
- ESPiLight - pilight 433.92 MHz protocols library for Arduino☆116Updated last year
- MiniESP for ESP01 and modules with few pins, enables GPIO 1/3 disables Serial output.☆29Updated 8 years ago
- Growatt Inverter monitoring via MQTT using ESP8266 modbus interface☆66Updated 4 years ago
- Esphome custom component for SDM energy meters☆13Updated 2 years ago
- Provide ESP8266 based itead Sonoff with Web, MQTT and OTA firmware using Arduino IDE, enhanced with I2C options☆126Updated last month
- ☆55Updated last month
- 1CH MQTT WiFi Relay/Thermostat Board☆31Updated 2 years ago
- Itead Studio SonoffSC custom firmware with MQTT and Domoticz support☆102Updated 5 years ago
- Digital version of my "analog" doorbell project to determine if the doorbell was pressed.☆58Updated 7 years ago
- EPSolar Solar Charge Controller to MQTT☆43Updated 3 years ago
- Readout of EMS protocol datagrams and transfer of data to Domoticz via Arduino☆88Updated 3 years ago
- A wrapper for ESPTOOL.exe + PowerShell to make flashing/programming ESP Easy units more streamline☆72Updated 3 years ago
- IOT-Light-Dimmer☆72Updated 4 years ago
- Low cost wifi alarm Wofea V10 Esphome hack☆24Updated 4 years ago
- Tasmota unofficial firmware builds. Install via Tasmota WebInstaller☆92Updated this week