Deutherius / Filament-Width-Comp-ExperimentsLinks
A couple of results from filament width compensation using a single mechanical/hall-effect based sensor
☆60Updated 3 years ago
Alternatives and similar repositories for Filament-Width-Comp-Experiments
Users that are interested in Filament-Width-Comp-Experiments are comparing it to the libraries listed below
Sorting:
- ☆75Updated 2 years ago
- ☆128Updated last year
- The Papilio is an extruder that uses GT2 Timing Belts instead of metal gears to push the filament.☆107Updated 6 months ago
- ERCF Filament Cutting Mod☆83Updated 2 years ago
- The Goliath Hotend☆100Updated 7 months ago
- Extruder based on MirageC HextrudORT☆116Updated 7 months ago
- ☆121Updated last year
- ☆156Updated 3 months ago
- A central purge bucket, wago mount, and cover plate for the Voron 2.4☆81Updated 3 years ago
- A series of scripts designed to streamline Klipper's resonance testing workflow.☆131Updated 4 months ago
- A set of Klipper extensions designed to improve operation of Voron printers.☆125Updated 3 months ago
- ☆118Updated last year
- A flexure based alternative to the Voron TAP☆83Updated last year
- Documentation for mods and group buys☆89Updated 3 years ago
- ☆140Updated last year
- ☆91Updated 7 months ago
- A new approach for belted Z motion using Nema17 Gearboxes☆133Updated last year
- "This is the Construct. It's our loading program. We can load anything... From clothing to equipment, weapons, training simulations; anyt…☆99Updated last month
- This is dedicated controller board for VORON ERCF (EnragedRabbitProject)☆55Updated 11 months ago
- non-linear frame deformation calibration and compensation 2.0☆79Updated 2 years ago
- ZeroPanels: the sealed, snap-in printer enclosure☆250Updated 11 months ago
- This Repo is my personal collection of useful Klipper guides and my printer configs.☆90Updated 2 years ago
- ☆57Updated last year
- "Crown" shaped cooling duct and associated hot end mount for Voron Trident and V2.4 printers☆119Updated 4 months ago
- Modification of the Mantis toolhead by Long/Mandryd for 4010 blowers and other miscellaneous adjustments☆133Updated 2 years ago
- A Fusion360 addin for optimizing counterbores for FDM 3d printing☆128Updated 9 months ago
- Contains supplementary information for the LDO Voron0.1 Kit☆104Updated 9 months ago
- A gantry mod for the Voron V0 that allows 142mm of X travel and 127mm of Y travel within the stock frame.☆91Updated 2 years ago
- Klipper Config for my Voron 2.4☆107Updated 3 months ago
- Klipper module for synchronizing two stepper motors located on one belt☆97Updated 2 weeks ago